- Integrated Toolcarrier:
- IT62H (S/N: M5G1-UP)
- Wheel Loader:
- 950H (S/N: N1A1-UP; M1G1-UP; J5J1-UP; K5K1-UP)
- 962H (S/N: N4A1-UP; M3G1-UP; J6J1-UP; K6K1-UP)
- 966H (S/N: A6D1-UP; A6G1-UP; A6J1-UP)
- 972H (S/N: A7D1-UP; A7G1-UP; A7J1-UP)
Description of Change: A new shunt tank is released. The routing for the vent is changed in order to improve the flow of engine coolant.
Adaptable To: The improvement is adaptable to first production of the machines that are listed above. The improvement is effective with the following machines:
- 950H (S/N: J5J562-UP; K5K1615-UP; M1G1129-UP; N1A1858-UP)
- 962H (S/N: J6J233-UP; K6K320-UP; M3G357-UP; N4A726-UP)
- IT62H (S/N: M5G358-UP)
- 966H (S/N: A6D1261-UP; A6G2435-UP; A6J765-UP)
- 972H (S/N: A7D536-UP; A7G811-UP; A7J255-UP)
Installation Procedure
Illustration 1 | g01343898 |
Coolant tank (1) 274-7407 Tee |
Loosen the hose clamps. Disconnect the existing hoses from 274-7407 Tee (1) on the coolant tank. Disconnect the hose from the bottom of the coolant tank. Remove the coolant tank.
Illustration 2 | g01414032 |
(2) 312-1735 Water Tank (3) 6S-8620 Hose Clamp (4) 5P-4924 Elbow (5) 3J-1907 O-Ring Seal (6) 5P-1046 Connector (7) 3J-7354 O-Ring Seal |
Install 312-1735 Water Tank (2). The new tank is mounted in the same location as the old tank. Reconnect the hose to the bottom of the tank.
Install 5P-4924 Elbow (4) with 3J-1907 O-Ring Seal (5) into the port on the right side of the tank. Connect the hose that was previously connected to the rear of the 274-7407 Tee (1) to 5P-4924 Elbow (4). Use 6S-8620 Hose Clamp (3) in order to secure the hose.
Install 5P-1046 Connector (6) with 3J-7354 O-Ring Seal (7) into the port on the front side of the tank. Connect the hose that was previously connected to the front of the 274-7407 Tee (1) to 5P-1046 Connector (6). Use 6S-8620 Hose Clamp (3) in order to secure the hose.