Transmission System Oil Filter - Replace
Show/hide table
 |
热油和热的部件可能会导致人身伤害。 不要让热油或热的部件与皮肤接触。 |
Show/hide table
| 注意 |
|---|
在检验、保养、测试、调整及维修发动机时，请小心确保盛接流出的液体。 在打开或拆解任何储有液体的部件之前，要准备好合适的容器收集液体。 有关适合收集和盛接卡特彼勒产品上的液体的工具和供应品，请参阅专门出版物, NENG2500, "卡特彼勒代理商工具目录"。 按照本地法规和条例处置所有液体。 |
最初，在 250 工时后更换变速箱机油滤清器。此后，每隔 500 工时后更换变速箱机油滤清器。
变速箱机油滤清器位于机器右侧的检修门后面。
- 从变速箱油滤清器底座卸下滤清器滤芯壳体 (1) 。 滤清器滤芯壳体位于机器右侧的检修门后面。
Show/hide table
 | |
| 图 1 | g01297817 |
- 从滤清器滤芯壳体 (1) 上拆卸滤清器滤芯，然后妥当废弃该滤芯。
- 用干净的布清洁滤清器滤芯壳体 (1) 。
- 检查密封圈。 如果密封损坏，更换密封。
- 将新滤芯装入滤清器滤芯壳体 (1) 内。
- 将滤清器壳体总成装入变速箱机油滤清器座内。拧紧滤清器壳体至扭矩 55 ± 5 N·m (40 ± 4 lb ft)。
- 起动发动机。
- 保持油位在油位表 (2) "满(FULL)"标记处。 必要时，通过加注管 (3) 加注机油。
- 关闭检修门。
- 停止发动机。
Caterpillar Information System:
572R Series II Pipelayer Transmission System Oil Level - Check
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes Input High Error IQAN XT2 A0-36
572R Series II Pipelayer Transmission System Oil - Change
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes Input High Error IQAN XT2 A0-39
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes Input High Error IQAN XT2 A0-38
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes Input High Error IQAN XT2 A0-37
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes Input High Error IQAN XT2 A0-23
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes Input High Error IQAN XT2 A0-22
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes Input High Error IQAN XT2 A0-21
14M Motor Grader Oil Filter (Implement Controls) - Replace
2006/09/11 Shims are Now Used in the Belt Tightener Group {1358}
C11 and C13 Engines and 14M and 16M Motor Graders Event Code List
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes Input High Error IQAN XT2 A0-35
572R Series II Pipelayer Transmission System Oil Sample - Obtain
C15 Petroleum Generator Set Engines Coolant Temperature Sensor
793D Off-Highway Truck Power Train Transmission Hydraulic Control - Remove
793D Off-Highway Truck Power Train Transmission Hydraulic Control - Install
16M Motor Grader Transmission and Differential Oil Level - Check
2006/08/14 An Improved Weld Is Now Used on the Undercarriage on Track Feller Bunchers {4150}
Procedure for Kidney Looping Wheel Harvester and Site Prep Tractor Hydraulic Oil{0680, 0738, 0768, 3000, 5050, 5056} Procedure for Kidney Looping Wheel Harvester and Site Prep Tractor Hydraulic Oil{0680, 0738, 0768, 3000, 5050, 5056}
572R Series II Pipelayer Transmission Magnetic Screen - Clean
793D Off-Highway Truck Power Train Flow Control and Relief Valve (Rear Axle Oil) - Disassemble
793D Off-Highway Truck Power Train Flow Control and Relief Valve (Rear Axle Oil) - Assemble
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes Input High Error IQAN XT2 A0-25