Control Valve (Moldboard)
Show/hide table
Illustration 1 | g01154566 |
(1) Tighten the valve to the following torque. ... 48 N·m (35 lb ft)
Relief valve pressure setting ... 10330 kPa (1500 psi)
(2) Tighten the valve to the following torque. ... 48 N·m (35 lb ft)
Pressure adjustment range ... 690 ± 6900 kPa (100 ± 1000 psi)
(3) Use one drop of 9S-3263 Thread Lock Compound on the threads of the solenoid assembly.
Tighten the three solenoids into the manifold to the following torque. ... 48 N·m (35 lb ft)
The coil is part of the solenoid.
Voltage ... 24 VDC Nominal
Wattage ... 20 Watts Nominal
(4) Tighten the nut to the following torque. ... 1.7 N·m (15 lb in)
Caterpillar Information System:
PM-201 Cold Planer Machine Systems Relief Valve (Steering)
PM-201 Cold Planer Machine Systems Auxiliary Pump
PM-201 Cold Planer Machine Systems Rear Valve
PM-201 Cold Planer Machine Systems Center Valve
C18 Engines for Caterpillar Built Machines Engine Pressure Sensor Open or Short Circuit - Test
PM-201 Cold Planer Machine Systems Metering Pump (Steering)
C9 Engines for Caterpillar Built Machines Electronic Control Module - Remove and Install
12M, 140M and 160M Motor Graders Hydraulic and Steering System Location Of Components
C11 and C13 Engines Fuel Temperature Sensor
Installation of a 3306 Engine Emissions Upgrade Group for a 12G Motor Grader{1000} Installation of a 3306 Engine Emissions Upgrade Group for a 12G Motor Grader{1000}
C7 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
730 EJECTOR Articulated Truck Machine Systems Fan Drive System
R2900G Load Haul Dump Machine Systems Ride Control Accumulator - Remove
R2900G Load Haul Dump Machine Systems Ride Control Accumulator - Install
C18 Engines for Caterpillar Built Machines Coolant Flow Switch Circuit - Test
730 EJECTOR Articulated Truck Machine Systems Hydraulic Tank
C9 Engines for Caterpillar Built Machines Cylinder Block Cover - Remove and Install
C7 Engines for Caterpillar Built Machines Crankshaft - Remove
C7 Engines for Caterpillar Built Machines Crankshaft - Install
C18 Engines for Caterpillar Built Machines CID 0782 FMI 05 Shutdown Lamp open/short to +batt
C18 Engines for Caterpillar Built Machines CID 0782 FMI 06 Shutdown Lamp short to ground
C18 Engines for Caterpillar Built Machines Engine Shutdown Switch Circuit - Test
793C Off-Highway Truck Fast Fill Service Center - If Equipped
C18 Generator Set Overspeed