Removal Procedure
| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| ZZ | 6V-9507 | Plug | 1 |
| 6V-9828 | Cap As | 1 | |
| 6V-9508 | Plug | 2 | |
| 6V-9829 | Cap As | 2 | |
Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
 |
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To help prevent possible injury, turn the start switch off when changing fuel filters or water separator elements. Clean up fuel spills immediately. |
 |
- Lower the screed.
- Disconnect harness assembly (3) .
 | |
| Illustration 1 | g01126858 |
- Disconnect hose assemblies (4) .
- Remove bolts (1) and fuel pump (5) and electric motor (2) .
- Remove fuel filter (8) from fuel pump (5) .
 | |
| Illustration 2 | g01127139 |
- Remove bolts (7) and remove fuel pump (5) from electric motor (2) .
- Loosen the screw and remove coupling (6) from fuel pump (5) .