Illustration 1 | g01019884 |
Display Area |
Setup Mode is mode 9 on all of the motor graders except the 143H and the 163H. Setup Mode is mode 10 on the 143H and the 163H. This mode is used in order to configure the installation status of the speedometer/tachometer module. If the speedometer/tachometer module is already installed, the display will read "t1 YES" when you enter the Setup Mode. If the speedometer/tachometer module is not installed, the display will read "t1 NO". In order to change the status of the module, ground the clear input for two seconds. If multiple speedometer/tachometer modules are present on the machine, grounding the service input for two seconds will display the status of the next module. For example, the display may read "t2 YES". The display will read "END" once you have scrolled through all of the modules. Grounding the service input for two seconds will start scrolling through the status of the modules again from the first module.