New Improved Gearbox Oil Heater is Now Used on Certain G3512E, G3516H, G3520C, and G3520H Generator Sets {1333}
- Engine
- G3512E (S/N: SST1-102)
- G3516H (S/N: NWJ1-107; GLN1-138)
- G3520C (S/N: LGS1-198)
- G3520H (S/N: GFR1-191)
- G3516H (S/N: NWJ1-107; GLN1-138)
- Generator Set
- CG170-16 (S/N: KSJ1-165)
Description Of Change: The new lower watt density heater is improved to prevent the over heating of oil and oil caking on the surface of the heater in the gearbox.
Adaptable To: The following changes are adaptable to the products within the listed serial numbers, and are effective with all products after the listed serial numbers.
Replace current heater with lower watt density heater to prevent oil caking on surface of heater.
Refer to Table 1 for the new and former parts.
Show/hide table
Qty | New Part Number | Part Name | Former Part Number |
---|---|---|---|
1 | Oil Heater Assembly | ||
1 | Oil Heater Assembly |
Caterpillar Information System:
A New Service Replacement Control Board (APC1+) is Now Used on Certain Cat® Uninterrupted Power Supply {1418, 4480} A New Service Replacement Control Board (APC1+) is Now Used on Certain Cat® Uninterrupted Power Supply {1418, 4480}
794 AC Off-Highway Truck Magnetic Plug (Wheels) - Check
C32 Marine Engines Electronic Control Module - Remove and Install
336, 336 GC and 340 Excavator Systems Pilot System
C7.1 Engines Coolant Pressure Is Low
C7.1 Marine Engine Exhaust Elbow - Remove and Install
The Buffer Seal Groove May Wear on the Steering Cylinder Head on Certain 773G and 777G Off-Highway Trucks {4303} The Buffer Seal Groove May Wear on the Steering Cylinder Head on Certain 773G and 777G Off-Highway Trucks {4303}
336, 336 GC and 340 Excavator Systems Stick Cylinder
320GC and 320 Excavator Engine Supplement Nitrogen Oxide Sensor - Remove and Install
C32 Marine Engines Inlet Air Temperature Sensor - Remove and Install
C32 Marine Engines Inlet Manifold Pressure Sensor - Remove and Install
C32 Marine Engines Speed/Timing Sensor - Remove and Install
New Jacket Water Bypass Tube is Now Used on Certain C175-20 Locomotive Engines {1380} New Jacket Water Bypass Tube is Now Used on Certain C175-20 Locomotive Engines {1380}
C32 Tier 4 Final Marine Commercial Engines DEF Pump Motor - Test
A New Plate-Type Heat Exchanger is Now Available for Certain Cat® 3516C Marine Engines {1379} A New Plate-Type Heat Exchanger is Now Available for Certain Cat® 3516C Marine Engines {1379}
A New Heat Shrink is Now Used for Certain Cat Electronic Control Module (ECM) Resistors {0644, 1901} A New Heat Shrink is Now Used for Certain Cat Electronic Control Module (ECM) Resistors {0644, 1901}
320GC, 320 and 323 Excavators Machine Systems Swivel - Remove and Install
794 AC Off-Highway Truck Electric Drive Pump (Powered Stairway) Oil - Change - If Equipped
794 AC Off-Highway Truck Electric Drive Pump (Powered Stairway) Oil Level - Check - If Equipped
336, 336 GC and 340 Excavator Systems Swing Motor
327-8644 Gauge Replacement {0374, 0701, 0763, 1214, 1215} 327-8644 Gauge Replacement {0374, 0701, 0763, 1214, 1215}
A New Integral Seal is Now Available for Certain 3524B Engines {1151, 1157, 1162, 1166, 1206, 3279, 7555} A New Integral Seal is Now Available for Certain 3524B Engines {1151, 1157, 1162, 1166, 1206, 3279, 7555}
PM820, PM822, and PM825 Cold Planer Machine Systems Hydraulic Cylinder (Rear Door) - Remove and Install
320GC Excavator Engine Supplement Hood - Remove and Install