Machine Security System (MSS3i) Integrated Caterpillar

Scheduled Access - Program - Security System Bypass

Usage:

Use the following procedure to change the Activation Periods of the Security System Bypass:

Note: Changing the MSS bypass times requires you to use a security ID with master access level or a factory password.

Insert a key or enter a passcode with master access level in the key start switch and turn to the ON position.
Show/hide table

Illustration 1 g06043780

Bypass Setup Screen
Select "Service" from the tool bar of the Cat ^® ET screen.
Select Machine Security System Install.
The menu to set up bypass times for machine operating hours will open for configuration.
Show/hide table

Illustration 2 g06043805

Typical ET screen
Double-click the "Security System Bypass Start Time" for the day that you want to set up. Double-click will launch the "Change Parameter Value" screen.
Show/hide table

Illustration 3 g06044148

Bypass Start Time Screen
Enter the desired "start time" in the space that is provided. Then click the "OK" button.
All times are based on a 24-hour clock. If you want the desired start time to be 6:00 am, then enter 06:00. If you want the desired start time to be 6:00 pm, then enter 18:00. Include the colon in the time setting or the MSS will not accept your entry.
Highlight the "Security System Bypass Stop Time" for the same day. Press the "Change" push button at the bottom of the page. This push button will bring up the "Change Parameter Value" screen. Enter the desired "stop time" in the space that is provided and click the "OK" button.
Repeat Steps 4 and 6 for all days which should have Bypass Activation Times.
To have the MSS armed 24 hours a day, repeat Steps 4 and 6 entering 00:00 as the "Start time" and 00:00 as the "Stop time".
Note: All times are based on a 24-hour clock. Refer to Testing and Adjusting, "Time - Set" for instructions on setting the date and the time of the MSS.