Electronic Control Module (Engine) - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect the negative battery terminal at the battery.
Show/hide table
Illustration 1 g03839056 - Disconnect harness assembly (1).
Show/hide table
Illustration 2 g03839068 - Remove bolts (2), electronic control module (3), and the ground strap.
Note: If the electronic control module (ECM) is being replaced, download the personality module before you remove the ECM. Refer to Troubleshooting, "Replacing the ECM".
- Install electronic control module (3) in the reverse order of removal.
Caterpillar Information System:
Installation Procedure for the Prelubrication Oil Pump on Certain G3500 Engines{1319} Installation Procedure for the Prelubrication Oil Pump on Certain G3500 Engines{1319}
3516C High Displacement Engine Electrical Power Supply - Test
3516B Generator Set Engines with Dynamic Gas Blending Fuel Consumption Is Excessive
3516C High Displacement Engine Cooling Fan Control - Test
3512C Generator Set Engine Air Starting Motor - Remove and Install
3512C and 3516C Industrial Engines Exhaust Manifold
3516B Generator Set Engines with Dynamic Gas Blending Engine Shutdown Occurs Intermittently
3516B Generator Set Engines with Dynamic Gas Blending Engine Stalls at Low RPM
120M Series 2, 12M Series 2, 140M Series 2 and 160M Series 2 Motor Graders Engine Air Filter Element - Clean/Replace
2015/06/26 New Software Is Used on 3512C Engines in 6060 Hydraulic Shovels {1920}
2015/05/28 Cat Reman Announces the Addition of Power Train Components for Mining Trucks {3030, 3258, 4008, 4051, 4201, 4251, 4267}
C4.4 and C7.1 Engines Electrical Connectors
3512C Generator Set Engine Fuel Filter Housing - Remove and Install
794 AC Off-Highway Truck Field Assembly Fuel Tank - Install
3516C High Displacement Engine Ether Starting Aid - Test
G3606 and G3608 Engines Crankcase Cover - Remove and Install
3516C High Displacement Engine Sensor Signal (Analog, Active) - Test
3516C High Displacement Engine Sensor Signal (PWM) - Test
3516C High Displacement Engine Sensor Supply - Test
C4.4 and C7.1 Engines Configuration Parameters
C4.4 and C7.1 Engines Diagnostic Trouble Codes
C4.4 and C7.1 Engines Acceleration Is Poor or Throttle Response Is Poor
C4.4 and C7.1 Engines Event Codes
C4.4 and C7.1 Engines Coolant Level Is Low