Engine Oil Filter
Show/hide table
Illustration 1 | g03836664 |
Show/hide table
Specification for 469-2677 Engine Oil Filter Gp     | |||
---|---|---|---|
Item     | Qty     | Part     | Specification Description     |
1     | 4     | 0S-1571 Bolt     | Torque to 47 ± 9 N·m (35 ± 7 lb ft). Use the following procedure in order to tighten the bolts of the clamp assembly: 1. Tighten the clamp assembly until the clamp assembly snug to tube. 2. Tighten the clamp assembly to the adapter. 3. Tighten the clamp assembly to the tube.     |
2     | 4     | 0S-1594 Bolt     | |
3     | 4     | 7G-6713 Spring     | Length under test force is 57.2 mm (2.25 inch). Test force is 109 ± 5 N (25 ± 1 lb). Free length after test is 99.7 mm (3.93 inch).     |
Caterpillar Information System:
3500 Industrial Engines Fuel Injector Mechanism
Instructions for Installing AssetIQTM for Commercial Generator Set Systems on Caterpillar and non-Caterpillar Products {4450, 7490} Instructions for Installing AssetIQTM for Commercial Generator Set Systems on Caterpillar and non-Caterpillar Products {4450, 7490}
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Left-Hand Service Oil
3516B Generator Set Engines with Dynamic Gas Blending Exhaust System Contains Oil
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Combined Circuit Keel Cooling
C280-08 Tier 4 Engine Exhaust Manifold Shield - Remove and Install
C9.3 Marine Engine Engine Oil Pan - Remove and Install - Right-Hand Service
3500 Generator Sets with Dynamic Gas Blending Generator Bearing - Replace
2015/08/14 A New Control Valve Assembly for Fuel Is Used on Certain 3500 Marine Engines {1261}
3500 Generator Sets with Dynamic Gas Blending Generator Bearing - Inspect
2015/07/07 An Improved Housing for the Throttle Inlet Is Used on Certain G3500 Engines {1071}
12M Motor Grader Wheel Lean Bearings - Lubricate
C280 Marine Engines Circuit Breaker - Test
3512C and 3516C Industrial Engines Air Lines
G3606 and G3608 Engines Aftercooler - Disassemble
C9.3 Marine Engine Coolant Temperature Sensor - Remove and Install
3516E Generator Set Engine Sensor Calibration Required - Test
C9.3 Marine Engine Engine Oil Pressure Sensor - Remove and Install
C280-08 Tier 4 Engine Exhaust Manifold - Remove and Install
C280-08 Tier 4 Engine Aftercooler - Remove and Install
C280-08 Tier 4 Engine Turbocharger - Remove and Install
C280-08 Tier 4 Engine Air Inlet Shutoff - Remove and Install
C9.3 Marine Engine Fuel Pressure Sensor - Remove and Install
C9.3 Marine Engine Speed/Timing Sensor - Remove and Install