Temperature Sensor (Cooled Exhaust Gas) - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | - | LOCTITE Nickel Anti-Seize | - |
- Disconnect harness assembly (1) and remove temperature sensor (2).
Show/hide table
Illustration 1 | g03783857 |
- Install temperature sensor (2) in the reverse order of removal.
- Apply Tooling (A) to threads of temperature sensor (2).
- Tighten temperature sensor (2) to a torque of
45 ± 5 N·m (33 ± 4 lb ft) .
Caterpillar Information System:
C13 Generator Set Engine Pressure Sensor (DPF) - Remove and Install
Turbine Blades May Shift In Certain C280 And 3600 Engine ABB Turbochargers{1052} Turbine Blades May Shift In Certain C280 And 3600 Engine ABB Turbochargers{1052}
C13 Generator Set Engine Temperature Sensor (Catalyst Inlet) - Remove and Install
Final Drive Motor Housings Are Available for Certain Excavators {4050} Final Drive Motor Housings Are Available for Certain Excavators {4050}
3516B Generator Set Engines with Dynamic Gas Blending Fuel Pressure Is Low
C13 Generator Set Engine Temperature Sensor (DPF Inlet, Flame Detect) - Remove and Install
C280 Marine Engines Fuel Pressure Is High
C13 Generator Set Engine Pressure Sensor (ARD Combustion Air) - Remove and Install
C4.4 and C6.6 Engines Crankcase Breather Ejects Oil
Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480} Procedure for Installing Three Phase Flywheel Inverter On Certain Uninterruptible Power Supply{4480}
C13 Generator Set Engine Fuel Temperature Sensor - Remove and Install
C13 Generator Set Engine Fuel Pressure Sensor - Remove and Install
C2.2 Engines for Caterpillar Built Machines Crankshaft
C13 Generator Set Engine Pressure Sensor (Cooled Exhaust Gas) - Remove and Install
C13 Generator Set Engine Pressure Sensor (NRS Differential) - Remove and Install
C13 Generator Set Engine Pressure Sensor (NRS Absolute) - Remove and Install
2015/05/15 A New Starter Is Now Available for Certain Cat® Generator Set Engines {1453}
C13 Generator Set Engine Boost Pressure Sensor - Remove and Install
C13 Generator Set Engine Inlet Air Temperature Sensor - Remove and Install
3516B Generator Set Engines with Dynamic Gas Blending Component Location
C13 Generator Set Engine Venturi Tube - Remove and Install
C7.1 Engines Aftertreatment Identification Module - Test
C2.2 Engines for Caterpillar Built Machines Piston and Rings
C7.1 Engines CAN Data Link - Test