Flywheel - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 138-7573 | Link Bracket | 2 |
B | FT2712 | Guide Stud | 2 |
C | 7M-7456 | Bearing Mount Compound | 1 |
- Raise the temperature of the ring gear to a maximum temperature of
315 °C (599 °F) . Position the ring gear with the part number toward the crankshaft. Install the ring gear on the flywheel. Allow the ring gear to cool. Use a soft hammer in order to seat the ring gear against the shoulder of the flywheel.Show/hide tableIllustration 1 g01010803 - Install Tooling (A) on flywheel (2). Fasten a suitable lifting device to flywheel (2). The weight of the flywheel is approximately
41 kg (90 lb) . - Place flywheel (2) on the crankshaft. Slide the flywheel over Tooling (B).
- Apply Tooling (C) to the threads of bolts (1).
- Install six of the eight bolts (1). Remove Tooling (B) from the end of the crankshaft and replace with the two remaining bolts. Tighten the bolts evenly to a torque of
300 ± 40 N·m (221 ± 30 lb ft) . - Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect" for the correct procedure.
Show/hide table
Always wear protective gloves when handling parts that have been heated. |
Caterpillar Information System:
C13 Engine Flywheel - Remove
Color Change for Cylinder Rod Seals (Wiper, U-Cup and Buffer){5100, 7555, 7562} Color Change for Cylinder Rod Seals (Wiper, U-Cup and Buffer){5100, 7555, 7562}
C13 Engine Water Temperature Regulator - Remove and Install
C13 Engine Water Pump - Install
C13 Engine Water Pump - Remove
3512C Engine for 785D Off-Highway Truck/Tractors Piston and Rings
C15 and C18 Engines for Caterpillar Built Machines Turbocharger
C13 Engine Engine Oil Pump - Install
C13 Engine Engine Oil Pump - Assemble
C13 Engine Engine Oil Pump - Disassemble
C13 Engine Engine Oil Pump - Remove
C13 Engine Engine Oil Cooler - Install
C13 Engine Flywheel Housing - Remove and Install
C13 Engine Rear Power Take-Off (RPTO) - Remove
C7 On-highway Engine Diesel Particulate Filter
C13 Engine Rear Power Take-Off (RPTO) - Install
C13 Engine Crankshaft Front Seal - Remove
C13 Engine Crankshaft Front Seal - Install
C13 Engine Front Cover - Remove
C13 Engine Front Cover - Install
C13 Engine Gear Group (Front) - Remove
C15 and C18 Industrial Engines Combustion Head - Remove and Install
C13 Engine Gear Group (Front) - Install
C13 Engine Housing (Front) - Remove