Flywheel
Show/hide table
图 1 | g00584712 |
典型实例 |
(1) 飞轮齿圈
- 将飞轮齿圈加热至以下温度。 ...
250 °C (480 °F)
注: 不要使用氧炔焊炬加热飞轮齿圈。
(2)飞轮
(3) 螺栓
- 拧紧 12 颗飞轮螺栓至以下扭矩。 ...
140 N·m (103 lb ft)
Caterpillar Information System:
C6.6 Industrial Engine Fuel Priming Pump
C6.6 Engines for Caterpillar Built Machines Fuel Injection Lines
C6.6 Industrial Engine Fuel Transfer Pump
C9 Generator Set Fuel System - Prime
C15 and C18 Petroleum Generator Sets After Starting Engine
3512C and 3516C Marine Auxiliary and Generator Set Engines Before Starting Engine
Caterpillar 270 Air Compressor Air Compressor is Noisy
Caterpillar 270 Air Compressor Air Compressor Cycles Constantly
C15 and C18 Petroleum Generator Sets Engine Oil Sample - Obtain
C13 and C15 On-highway Engines Clean Gas Induction - Test
Caterpillar 270 Air Compressor General Troubleshooting Information
Caterpillar 270 Air Compressor No Compression of Air (Unloaded)
C7.1 Engines for Caterpillar Built Machines Exhaust Manifold
Caterpillar 270 Air Compressor Air Compressor Leaks Coolant
Caterpillar 270 Air Compressor Air Compressor Leaks Oil
C3.3 Industrial Engine Accessory Drive - Remove and Install
C15 On-Highway Engine Electronic Unit Injector - Adjust
C32 Marine and Auxiliary Marine Engines Engine Oil Filter Base - Remove
C7.1 Engines for Caterpillar Built Machines Front Housing and Covers
C9 Generator Set Engine Crankcase Breather - Clean
C7.1 (Mech) Industrial Engine Oil Pump
Caterpillar 270 Air Compressor Excessive Build-Up and Recover Time
Caterpillar 270 Air Compressor Excessive Oil at Exhaust Ports or Air Strainer
Caterpillar 270 Air Compressor Air Compressor Governor - Test and Adjust