Indicators and Gauges - Test
The system performs an automatic self test when you turn the engine start switch to the ON position.
Show/hide table
Illustration 1 | g01061080 |
The operator must observe the outputs in order to determine if the modules are operating properly. This self testing feature is three seconds long.
During the self test, all alert indicators flash.
The digital display window shows the following readouts:
- All indicators of units (Deg C, kPa, miles, kilometers, rpm, and liters)
- "X10"
- Symbol for the hour meter
- "8.8.8.X8.8" readout
The pointers in the tachometer and in the gauges point upward. The pointers will then point to the left. The pointers will then point to the right. The pointers will then point to the final position.
- The readout of the gear shows "**".
- The speed readout shows "188", "MPH", and "km/h".
- The action light stays illuminated.
- The action alarm sounds once.
The monitoring panel is then in the normal operating mode. If a switch is grounded, the monitoring system will display the modes.
Make any necessary repairs before you operate the machine.
Caterpillar Information System:
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarriers Machine Systems Pilot Valve - Assemble
914G and 914G2 Compact Wheel Loaders and IT14G and IT14G2 Integrated Toolcarriers Machine Systems Pilot Valve - Disassemble
D11R Track-Type Tractor Cooling System Coolant Sample (Level 2) - Obtain
D11R Track-Type Tractor Cooling System Coolant Sample (Level 1) - Obtain
D11R Track-Type Tractor Cooling System Coolant Extender (ELC) - Add
D10R Track-Type Tractor Bulldozer Tilt Brace
D10T Track-Type Tractor Power Train Transmission Hydraulic Control
Dimensions for the 994 Wheel Loader Hitch{7051, 7054, 7057, 7100} Dimensions for the 994 Wheel Loader Hitch{7051, 7054, 7057, 7100}
D11R Track-Type Tractor Operation Information
D10R Track-Type Tractor Engine Starting with Prelubrication System
988G Wheel Loader Power Train Torque Converter (Lockup) - Assemble
950G Series II Wheel Loader System Components
966G II and 972G II Wheel Loaders Autoshift Control
D10R Track-Type Tractor Cooling System Coolant (ELC) - Change
992G Wheel Loader Ether Starting Aid Cylinder - Replace - If Equipped
D10R Track-Type Tractor Engine Valve Lash - Check/Adjust
994F Wheel Loader Fuses - Replace
950G Series II Wheel Loader Hydraulic Tank
2004/04/12 A Tolerance Has Been Added to the Positioning of Lubrication Holes on Lift Arm Pins {6107, 6118}
950G Series II Wheel Loader Hose and Coupling
950G Series II Wheel Loader Accumulator
992G Wheel Loader Electrohydraulic System Position Sensor (Lift Linkage) - Calibrate
992G Wheel Loader Electrohydraulic System Position Sensor (Tilt Linkage) - Calibrate
994F Wheel Loader Safety Messages