Engine Oil Filter Base - Disassemble - Spin-on Filters
开始:
- 拆卸机油滤清器座。 参考拆解与组装, "发动机机油滤清器座 - 拆卸"。
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 拆卸弯管 (1)、支架 (2)和接头 (3)。
- 拆卸每个座上的盖 (4)、密封垫 (5)、弹簧 (6)和活塞 (7)。
- 拆卸固定底座组件的螺栓 (8)。
- 如有必要，从底座组件上拆卸柱形螺栓。
Show/hide table
| |
| 图 1 | g00604316 |
Show/hide table
 |
|
弹簧加压的零件和/或盖板可能导致人身伤害。 拆卸盖板时弹簧力将被释放。 松动螺栓时做好准备把持住弹簧加载的盖板。 |
Caterpillar Information System:
3500B Engines Engine Oil Filter Base - Remove - Spin-on Filters
3500B Engines Engine Oil Filter Housing - Install
3114, 3116 and 3126 Engines Engine Stalls at Low RPM
3114, 3116 and 3126 Engines Engine Oil in Exhaust System
3500B Engines Engine Oil Filter Housing - Remove
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Travel Hydraulic System
3114, 3116 and 3126 Engines Engine Oil in Cooling System
3500B Engines Engine Oil Pump - Install
3500B Engines Engine Oil Pump - Assemble
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Alternator and Regulator
3500B Engines Engine Oil Pump - Disassemble
3500B Engines Engine Oil Pump - Remove
3306B Generator Set Electronic Modular Control Panel II (EMCP II)
3500B Engines Engine Oil Filter Base - Assemble - Spin-on Filters
3606 and 3608 Engines Pressure Regulating Valve
3500B Engines Engine Oil Filter Base - Install - Spin-on Filters
3114, 3116 and 3126 Engines Engine Vibration
3606 and 3608 Engines General Information (Cooling System)
3114, 3116 and 3126 Engines Engine Will Not Crank
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Inlet Manifold - Install - 3013, 3014, and 3024 Engines
3114, 3116 and 3126 Engines Excessive Black Smoke
3176B Marine Engine Starting the Engine
G3612 and G3616 Engines Exhaust Bypass - Install
G3612 and G3616 Engines Crankcase Pressure Sensor - Remove and Install