Fan Drive - Assemble
Assembly Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 1P-0510     | Driver Group     | 1     |
B     | 1P-0808     | Multipurpose Grease     | -     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install bearing (4) in pulley (5) .
Show/hide table
Illustration 1 | g01029786 |
- Install lip seal (3) with Tooling (A), as shown. Apply Tooling (B) to the lip of the seal.
- Install spacer (2) so the end with the taper is toward the inside of pulley (5) .
- Install spacer (6) and bearing (9) in the front of pulley (5) .
- Position O-ring seal (7) on the front of pulley (5). Install the pulley on shaft assembly (1) .
- Install retainer (10) and bolts (11). Tighten bolts (11) to a torque of 25 ± 6 N·m (18 ± 4 lb ft).
- Install the fan adapter on pulley (5). Tighten bolts (8) to a torque of 47 ± 9 N·m (35 ± 7 lb ft).
- Fill the fan drive with Tooling (B) .
End By: Install the fan drive. Refer to Disassembly and Assembly, "Fan Drive - Install".
Caterpillar Information System:
3304B and 3306B Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
3406E On-Highway Engine Fan Drive - Disassemble
G3300 Engines Cylinder Pressure - Measure/Record
3524B Engines for Off-Highway Trucks Too Much Valve Lash
3176C Engine Cylinder Liner
3406E On-Highway Engine Housing (Front) - Install
3406E On-Highway Engine Housing (Front) - Remove
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Assemble
3524B Engines for Off-Highway Trucks Too Much Vibration
C-12 Truck Engine Cylinder Liner
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Disassemble
3406E and 3456 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove
3406E On-Highway Engine Fan Drive - Remove
3406E and 3456 Generator Set Engines Fan Drive - Install
G3300 Engines Engine Air Cleaner Service Indicator - Inspect
3176C Engine Cooling System Coolant (DEAC) - Change
3406E Engine Speed/Timing Sensor - Remove and Install
3406C (PEEC III) Truck Engines Glossary of Electronic Control Terms
3406E On-Highway Engine Coolant Temperature Sensor - Remove and Install
3406E On-Highway Engine Engine Oil Pressure Sensor - Remove and Install
3500 Spark Ignited Engines Engine Design
318B Excavator Machine System Specifications Track Roller (Single Flange)
G3300 Engines Ignition System Spark Plugs - Inspect/Replace
C-9 Engine for TK711, TK721, TK722, TK732, TK741, TK751, and TK752 Track Feller Bunchers Engine Oil in Cooling System