Engine Trunnion - Remove and Install
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件名称 | 数量 |
A | 180-3034 | 一套修理支架 | 1 |
B | - | 导向螺栓
1/2 - 13 NC,8 英寸 |
2 |
开始:
- 拆下减震器。 请参考拆卸和组装, "气门盖底座 - 拆除和安装"部分。
- 使用适当的吊具提起发动起前部,然后将发动机放在工具 (A) 上。 发动机的重量约为
4490 千克 (9900 磅) 。 拆下两只螺栓 (1)。Show/hide table图 2 g01210000 - 安装工具 (B)。 拆下其余的螺栓 (1)。
Show/hide table
图 3 g00916552 - 将发动机耳轴 (2) 向外滑出,将适当的吊具系缚在发动机耳轴 (2) 上。 拆下发动机耳轴 (2)。 发动机耳轴 (2) 的重量约为
54 千克 (120 磅) 。
Show/hide table
图 1 | g00916548 |
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件名称 | 数量 |
A | 180-3034 | 一套修理支架 | 1 |
B | - | 导向螺栓
1/2 - 13 NC,8 英寸 |
2 |
- 将适当的吊具系缚到发动机耳轴 (2) 上。 将发动机耳轴 (2) 放置到位,然后将发动机耳轴 (2) 滑到工具 (B) 上。 发动机耳轴 (2) 的重量约为
54 千克 (120 磅) 。Show/hide table图 5 g01210000 - 安装螺栓 (1)。 拆下工具 (B)。
Show/hide table
图 6 g00916548 - 安装其余的螺栓 (1)。 使用适当的吊具提起发动机的前部。 拆下工具 (A)。 发动机的重量约为
4490 千克 (9900 磅) 。
Show/hide table
图 4 | g00916552 |
结束:
- 安装减震器。 请参考拆卸和组装, "气门盖底座 - 拆除和安装"部分。
Caterpillar Information System:
Air Conditioning and Heating R-12 All Caterpillar Machines General Information
2002/09/16 New Pins for the Bulldozer Blade are Now Greased {6061, 6065, 6066}
2003/04/21 A Sight Gauge for the Transmission Oil Level and an Oil Filler Tube at Ground Level are Available {3030}
2002/09/16 The Coils for the Directional Control Valve are now Serviced {5051}
Air Conditioning and Heating R-12 All Caterpillar Machines Machine Preparation for Disassembly and Assembly
574B Forwarder Power Train Power Train Charge System Pressure - Test
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Pulled Unit Hydraulics, Torque Converter, and Brake System Troubleshooting
776D, 777D and 777D HAA Off-Highway Truck/Tractors Air System and Brakes Hoist, Torque Converter, and Brake System Troubleshooting
R2900 Load Haul Dump Steering Control
924H, 924HZ, 928HZ and 930H Wheel Loaders Axle Oil Cooler Screen - Clean/Replace
2002/11/11 New Mirror Has Improved Durability and a New Support that Reduces Vibration {7319}
120H, 12H, 135H, 140H, 143H, 14H, 160H, 163H and 16H Motor Graders Secondary Steering System Hydraulic Schematic
Air Conditioning and Heating R-12 All Caterpillar Machines Refrigerant Compressor - Remove and Install
Air Conditioning and Heating R-12 All Caterpillar Machines Refrigerant Accumulator - Remove and Install
Air Conditioning and Heating R-12 All Caterpillar Machines Refrigerant Expansion Valve - Remove and Install
Air Conditioning and Heating R-12 All Caterpillar Machines Receiver-Dryer - Remove and Install
Air Conditioning and Heating R-12 All Caterpillar Machines In-Line Refrigerant Dryer - Remove and Install
Air Conditioning and Heating R-12 All Caterpillar Machines Refrigerant Orifice Tube - Remove and Install
TK711, TK721, TK722 and TK732 Track Feller Bunchers Hydraulic System Main Control Valve
R2900 Load Haul Dump Joystick Control
AP-655C and BG-2255C Asphalt Pavers Machine Systems Hydraulic Tank
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Engine Oil Pump - Remove
AP-655C and BG-2255C Asphalt Pavers Machine Systems Suction Strainer
Medium Wheel Loaders (MWL) Payload Control System (PCS) 3.0 Electronic Control Module (ECM) - Flash Program