Illustration 1 | g00814839 |
Maximum operating pressure of the cylinder ... 34300 kPa (4975 psi)
(1) Torque for 7Y-4956 Locknut ... 10000 ± 500 N·m (7400 ± 370 lb ft)
(2) Lubricate the inside diameter and outside diameter with the lubricant that is being sealed.
(3) 162-5830 Rod
- Outside diameter ... 109.93 mm (4.328 inch)
- Plating thickness ... 0.025 mm (.0010 inch)
(4) Bore of 7Y-4932 Head ... 112.10 ± 0.10 mm (4.413 ± .004 inch)
Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward.
(5) 128-9885 Bearing
- Outside diameter ... 130.240 ± 0.013 mm (5.1275 ± .0005 inch)
- Inside diameter ... 110.300 ± 0.020 mm (4.3425 ± .0008 inch)
- Bearing coating thickness ... 0.030 ± 0.005 mm (.0012 ± .0002 inch)
- Inside diameter ... 110.300 ± 0.020 mm (4.3425 ± .0008 inch)
Bearing must be centered in the bore when you install the bearing in the rod or the cylinder.
(6) Bore of 162-5828 Cylinder Assembly ... 170.0 ± 0.10 mm (6.69 ± .004 inch)
(7) Lubricate the sealing lip slightly with the lubricant that is being sealed.
(8) Prior to assembly, apply 7M-7456 Bearing Mount Compound to the groove for the wiper seal.