Electric Drive Pump (Secondary Steering and Brake Release) - Install
Show/hide table
| 所需工具 | |||
|---|---|---|---|
| 工具 | 零件号 | 零件说明 | 数量 |
| A | 138-7575 | 连杆支架 | 1 |
注: 检查所有 O 形密封圈和部件有无磨损或损坏。 如有必要，请更换部件。 利用正要密封的润滑剂稍微润滑所有 O 形密封圈。 利用不起毛的抹布擦拭所有部件。
- 将适当的吊索绕电动泵 (4) 放置。 将适当的起吊设备固定在举倾机构上。 将电动泵 (4) 提升到图中所示的位置。 电动泵的重量为
26 kg (57 lb) 。 - 将固定电动泵 (4) 的四个螺母 (13) 和硬垫圈安装到机器上。
Show/hide table
图 2 g00697544 - 将软管组件 (9)、软管组件 (10) 和软管组件 (12) 与电动泵相连接。
- 将软管组件 (7)、软管组件 (8) 和软管组件 (11) 与电动泵相连接。
Show/hide table
图 3 g00697543 - 将电缆组件 (5) 和电缆组件 (6) 与电动泵 (4) 相连接。
Show/hide table
图 4 g00697541 - 将工具 (A) 固定至板 (3)。 将适当的吊索固定到工具 (A) 上。 将吊索固定到适当的举倾机构上。 提升板 (3) 至图中所示位置。 安装四个螺栓 (2) 和垫圈。 安装螺栓 (1) 和垫圈。
- 给转向油箱加油。 请参阅操作和保养手册, "转向系统油 – 更换"。
Show/hide table
| |
| 图 1 | g00697545 |
Caterpillar Information System:
216, 226 and 228 Skid Steer Loaders Powertrain Piston Motor (Hydrostatic) - Remove and Install
C-10, C-12, C-15 and C-16 Industrial Engines CID 0320 FMI 02 Speed/Timing Sensor Loss of Signal
776D, 777D and 777D HAA Off-Highway Trucks Machine Systems Electric Drive Pump (Secondary Steering and Brake Release) - Remove
CS-431C, CP-433C and CS-433C Vibratory Compactors Propel System Case Drain Flow for Piston Motor (Drum Propel) - Test
2014/02/20 Correction to Service Magazine, SEPD0533 , "A New Inlet Valve is Released for use in 3116 and in 3126 Machine Engines with Two Valve Configuration" {1105}
3114, 3116, and 3126 Engines Basic Engine
D400E Series II Articulated Truck Steering, Suspension, and Ejector Body Hydraulic Systems Signal and Pressure Reducing Valve (Steering)
D400E Series II Articulated Truck Steering, Suspension, and Ejector Body Hydraulic Systems Signal and Pressure Reducing Valve (Steering)
D400E Series II Articulated Truck Steering, Suspension, and Ejector Body Hydraulic Systems Secondary Steering Pump and Electric Motor
776D, 777D and 777D HAA Off-Highway Trucks Machine Systems Slack Adjuster (Rear) - Install
TH62, TH63, TH82, TH83 and TH103 Telehandlers Longitudinal Stability Indicator System Calibration
776D, 777D and 777D HAA Off-Highway Trucks Machine Systems Slack Adjuster (Rear) - Remove
D400E Series II Ejector Truck Steering, Suspension, and Ejector Body Hydraulic Systems Ejector Cylinder
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Pump - Inspect
Connection Diagrams: SR4 and SR4B Generators, Voltage Regulators, Options General Information (SR4B for 3500 Engines)
Connection Diagrams: SR4 and SR4B Generators, Voltage Regulators, Options Generator Wiring Diagrams (SR4B for 3500 Engines)
Connection Diagrams: SR4 and SR4B Generators, Voltage Regulators, Options Main Stator and Voltage Sensing Lead Connections (All Except SR4B for 3500 Engines)
3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders Event Codes
2000/05/22 New Seal Retainers and a New Plate Are Used with Duo-Cone Seals in Order to Increase Performance {4251, 4267, 7561}
CS-431C, CP-433C and CS-433C Vibratory Compactors Propel System Thermal Bypass Valve - Test
3508B Engine for 854G Wheel Dozers and 992G Wheel Loaders E017 High Engine Coolant Temperature Warning
3456 Engines for Caterpillar Built Machines E035 Loss of Coolant Flow Warning
3126B Engine for Caterpillar Built Machines Flash Programming
776D, 777D and 777D HAA Off-Highway Trucks Machine Systems Diverter Valve (Parking Brake Release) - Remove