Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Caterpillar


Fuses - Replace

Usage:

45 3BK


NOTICE

Always replace fuses with the same type and capacity fuse that was removed. Otherwise, electrical damage could result.


Fuses protect the electrical system from damage that is caused by overloaded electrical circuits. Replace a fuse if the element separates. If the fuse of a particular electrical system requires frequent replacement, check the electrical circuit. Repair the electrical circuit, if necessary. The fuses are located in the main fuse panel, in the main distribution panel, and behind the right side console.

Main Fuse Panel




Illustration 1g00323525

The fuses are located below the seat.

In order to access fuse panel (1), release tabs (2). Then, remove cover (3).

Table 1
Main Fuse Panel    
Number     Rating     Color     Description    
1     Spare fuse    
2     50 Amp     Red     Main Fuse I    
3     40 Amp     Orange     Transmission    
4     50 Amp     Red     Roading lights    
5     50 Amp     Red     Work lights
   
6     40 Amp     Orange     Main Fuse II    
7     40 Amp     Orange     Accessory    
8     40 Amp     Orange     Implement socket    

Main Distribution Panel




Illustration 2g00330885

The main distribution panel is located behind the cover above the right console.

In order to access panel (6), release latches (4). Then, remove cover (5) .

Relays are located in the right column. Fuses are located in the left column.

Relays




Illustration 3g00331224

Table 2
Relays    
Number     Description    
1     Lower front work lights and side work lights    
2     Lower, cab mounted rear work lights    
3     Upper, cab mounted rear work lights    
4     Upper, cab mounted front work lights    
5     Power take-off    
6     Transmission directional interrupt    
7     Brakes    
8     Cold start    
9     Accessory power    
10     Auxiliary power #2    
11     Power for the transmission    
12     Auxiliary power #1    
13     Flasher module    
14     NASO/ISO Turn Signal and converter for the Flasher module    
15     NASO/ISO Turn Signal and converter for the Flasher module    
16     Fuel solenoid    
17     Power supply to an implement    

Fuses




Illustration 4g00331293

Table 3
Fuses    
Number     Rating     Color     Description    
1     10 Amp     Red     Accessory socket    
2     25 Amp     Transparent     Heating and air conditioning control    
3     15 Amp     Blue     Wiper/Washer    
4     20 Amp     Yellow     Front work lights and middle work lights    
5     20 Amp     Yellow     Lower, cab mounted rear work lights    
6     15 Amp     Blue     Upper, cab mounted rear work lights    
7     15 Amp     Blue     Upper, cab mounted front work lights    
8     7.5 Amp     Brown     Right side parking light    
9     7.5 Amp     Brown     Left side parking light    
10     25 Amp     Transparent     Main work light    
11     15 Amp     Blue     Cigar lighter
Horn
Rotating Beacon    
12     15 Amp     Blue     Brake lights    
13     15 Amp     Blue     Hazard lights    
14     5 Amp     Tan color     Interior lights    
15     7.5 Amp     Brown     Movable console    
16     20 Amp     Yellow     Seat    
17     7.5 Amp     Brown     Power for the radio    
18     20 Amp     Yellow     Solenoids for transmission control (Fuse #1)    
19     20 Amp     Yellow     Transmission solenoid for FORWARD/REVERSE shifting (Fuse #2)    
20     15 Amp     Blue     Transmission solenoid for FORWARD/REVERSE shifting
PTO    
21     5 Amp     Tan color     Right side console    
22     5 Amp     Tan color     Front Console    
23     10 Amp     Red     Control module (VPWR)    
24     15 Amp     Blue     Turn signal    
25     5 Amp     Tan color     Unswitched battery line "+" for the memory (KAPWR)    
26     10 Amp     Red     Ignition switch
Diagnostic connector    
27     15 Amp     Blue     Air inlet heater    
28     15 Amp     Blue     High beam headlamps    
29     15 Amp     Blue     Low beam headlamps    
30     15 Amp     Blue     Implement monitor    

Right Hand Console

Fuses




Illustration 5g00513121

Six fuses are located behind the right hand console.

Table 4
Right Hand Console    
Rating     Color     Description    
10 Amp     Red     Accessory socket I (1)    
10 Amp     Red     Accessory socket II (1)    
30 Amp     Green     Accessory socket I (2)    
30 Amp     Green     Accessory socket II (2)    
10 Amp     Red     Trailer accessory I    
10 Amp     Red     Trailer accessory II    
( 1 ) This socket is not switched by the engine start switch key.
( 2 ) This socket is switched by the engine start switch key.

Relays

Four relays are located behind the right hand console. The relays are for the following components:

  • Accessory socket I

  • Accessory socket II

  • Trailer accessory I

  • Trailer accessory II

Caterpillar Information System:

3406E On-Highway Engine Electronic Unit Injector - Install
527 Track-Type Skidder Hydraulic System Hydraulic Tank and Filter
3176C and 3196 Engines For Caterpillar Built Machines Engine Oil Filter Base - Assemble
527 Track-Type Skidder Hydraulic System Relief Valve For Grapple Tong Cylinder
527 Track-Type Skidder Fuel System Primary Filter - Clean
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Power Train Transmission Oil Cooler
3304B and 3306B Engines for Caterpillar Built Machines Rocker Shaft - Assemble
3176C and 3196 Engines For Caterpillar Built Machines Engine Oil Filter Base - Disassemble
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Power Train Transmission Oil Reservoir
527 Track-Type Skidder Hydraulic System Bulldozer Angle Control Valve
527 Track-Type Skidder Fan Drive Bearing - Lubricate
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Power Train Transmission Oil Filter
D350E Series II Articulated Truck Tailgate Cylinder - Install
773D Off-Highway Truck and 775D Quarry Truck Selector and Pressure Control Valve (Transmission)
527 Track-Type Skidder Hydraulic System Bulldozer Lift Cylinder
527 Track-Type Skidder Hydraulic System Bulldozer Angle Cylinder
IT14G Integrated Toolcarrier and 914G Wheel Loader Steering System Check Valve
IT14G Integrated Toolcarrier and 914G Wheel Loader Steering System Flow Switch
IT14G Integrated Toolcarrier and 914G Wheel Loader Steering System Gear Pump
D250E Series II and D300E Series II Articulated Trucks Machine Systems Service Brake Control Valve - Remove and Install
IT14G Integrated Toolcarrier and 914G Wheel Loader Steering System Steering and Brake Manifold Valve
527 Track-Type Skidder Hydraulic System Bulldozer Tilt Cylinder
IT14G Integrated Toolcarrier and 914G Wheel Loader Steering System Priority Valve
IT14G Integrated Toolcarrier and 914G Wheel Loader Steering System Articulated Hitch
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.