 | |
| Illustration 1 | g00904440 |
(A) Adjust the shroud to the proper clearance. ... 1.0 + 2.0 - 0.5 mm (0.04 + 0.08 - 0.02 inch)
Note: Tractors do not have a shroud.
(2) Torque for 24 studs ... 170 ± 30 N·m (125 ± 22 lb ft)
(3) Torque for 24 nuts ... 430 ± 60 N·m (317 ± 44 lb ft)
(4) Torque for 26 nuts ... 430 ± 60 N·m (317 ± 44 lb ft)
(5) Torque for 16 nuts ... 440 ± 40 N·m (325 ± 30 lb ft)
(6) Install the two pins above the bore. ... 7.6 ± 0.5 mm (0.30 ± 0.02 inch)
(7) 9M-5874 Shim Pack
- Quantity ... As required
- Shim Pack thickness ... 0.130 mm (0.005 inch)
Note: Refer to Testing and Adjusting, "Differential and Bevel Gear - Adjust" before shims (7) are installed.
(8) Final torque for 18 bolts ... 50 ± 5 N·m (37 ± 4 lb ft)
Note: Bolts (8) must be turned 60 degrees past the final torque.
(9) Lubricate the sealing lip with a small amount of the lubricant that is being sealed.
(10) Lubricate the bore with a small amount of the lubricant that is being sealed.
(11) 125-8649 Shim
- Quantity ... 10
- Thickness ... 0.12 mm (0.005 inch)
125-8650 Shim
- Quantity ... 10
- Thickness ... 0.18 mm (0.007 inch)
 | |
| Illustration 2 | g00904496 |
View A-A | |
(12) Torque for four bolts ... 1300 ± 150 N·m (959 ± 111 lb ft)
 | |
| Illustration 3 | g00904480 |
View B-B | |
 | |
| Illustration 4 | g00904481 |
View C-C | |
(13) Apply 155-0695 Thread Lock Compound to the threads of the bolts before installation.