Illustration 1 | g01435099 |
Top view |
Illustration 2 | g01435100 |
View A-A |
NOTICE |
---|
Do not use any caustic (corrosive) materials in order to clean any parts of this group. Caustic materials will cause corrosion and damage to the parts. |
(2) Refer to Specifications, "Solenoid Valve (Transmission)".
(3) The notch on the connector for the wiring harness should face upward. The centerline of the notch on the connector should be parallel with the mounting face of the switch.
(4) Torque for the four bolts that are marked with an "X" ... 48 ± 4 N·m (35 ± 3 lb ft)
(5) Torque for five bolts ... 30 ± 4 N·m (22 ± 3 lb ft)
(6) Torque for bolt ... 48 ± 4 N·m (35 ± 3 lb ft)
(7) Torque for bolt ... 30 ± 4 N·m (22 ± 3 lb ft)
(8) Torque for two bolts ... 48 ± 4 N·m (35 ± 3 lb ft)
(9) Lubricate the sealing lip with a small amount of the lubricant that is being sealed.
Before you install the lip seal, put a coat of 7M-7260 Liquid Gasket on the sealing bore. Allow the liquid gasket to dry before you install the seal. Do not put any liquid gasket on the lip seal. Install the seal so that the seal lip faces the inside of the component.
(10) Torque for two bolts ... 48 ± 4 N·m (35 ± 3 lb ft)
(11) Transmission Gear Switch
(12) Refer to Specifications, "Lubrication Relief Valve (Transmission)".
- Installation torque ... 41 ± 7 N·m (30 ± 5 lb ft)
Illustration 3 | g01435102 |
3T-0289 Valve |
(13) 3T-0289 Valve
All of the valves in this group must be tested as a unit. All of the valves in this group must be assembled into the transmission as a unit. Individual parts of this unit may not be interchanged at any time after the unit has been tested. During repair service, individual parts of this group will be furnished.
(14) Refer to Specifications, "Pressure Control Valve (Transmission)".
(15) Refer to Specifications, "Selector and Pressure Control Valve (Transmission)".
(16) Refer to Specifications, "Rotary Actuator (Transmission)".
(17) Torque for two bolts ... 30 ± 4 N·m (22 ± 3 lb ft)
(18) Torque for 12 bolts ... 30 ± 4 N·m (22 ± 3 lb ft)