Starting Above 0°C (32°F)
Show/hide table
 | |
| Illustration 1 | g00101747 |
Show/hide table
 | |
| Illustration 2 | g00451386 |
- Move both the transmission direction control lever and the direction control switch (if equipped) into NEUTRAL.
- Lift the steering column release lever and move the steering column to the desired position. Release the steering column release lever in order to lock the steering column into position.
- Engage the parking brake.
Show/hide table
 | |
| Illustration 3 | g00451389 |
- Move the control levers to the HOLD position.
- Turn the engine start switch to the ON position. Pause for three seconds so that the secondary steering self-test (if equipped) can test.
- Push the accelerator pedal to the floor. Then, release the pedal to approximately 1/3 pedal travel and hold the pedal.
- Turn the engine start switch key in order to start the engine. Release the key and the accelerator pedal when the engine starts.
Show/hide table
| NOTICE |
|---|
Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again. Turbocharger damage can result, if the engine is not kept low until the engine oil light/gauge verifies the oil pressure is sufficient. |
Caterpillar Information System:
416C, 426C, 428C, 436C and 438C Backhoe Loaders Seat Adjustment and Seat Belt Inspection
120H and 135H Motor Graders Air System and Brakes Check Valve (Parking Brake Release)
416C, 426C, 428C, 436C and 438C Backhoe Loaders Mounting and Dismounting
12H, 140H and 160H Motor Graders Air System and Brakes Stop Light Air Pressure Switch
143H and 163H Motor Graders Air System and Brakes Pressure Switch (Brake Air) (Parking Brake)
143H and 163H Motor Graders Air System and Brakes Pressure Switch (Low Brake Air)
12H, 140H and 160H Motor Graders Air System and Brakes Front Wiring
120H and 135H Motor Graders Air System and Brakes Front Wiring
120H and 135H Motor Graders Air System and Brakes Air Tank
966G and 972G Wheel Loaders Display Modules (Caterpillar Monitoring System)
120H and 135H Motor Graders Air System and Brakes Air Tank
928G Wheel Loader Seat
928G Wheel Loader Starting Below 0°C (32°F) with Thermal Starting Aid
554 Forwarder and 574 Forwarder Engine Starting with Jump Start Cables
824G Wheel Dozer, 825G Soil Compactor and 826G Landfill Compactor Hydraulic System Detent Coil (Control Lever)
938G Wheel Loader and IT38G Integrated Toolcarrier Engine Starting with Auxiliary Start Receptacle - If Equipped
928G Wheel Loader After Starting Engine
966G and 972G Wheel Loaders Excavating with Bucket
938G Wheel Loader and IT38G Integrated Toolcarrier Parking Brake
928G Wheel Loader Secondary Steering
928G Wheel Loader Accelerator Control
966G and 972G Wheel Loaders Logging Fork Clamp
966G and 972G Wheel Loaders Operating Technique Information
966G and 972G Wheel Loaders Bucket Loading from a Stockpile