Timing Gear Housing
Usage:
(1) Torque for stud on back of the housing ... 20 ± 3 lb. ft.(25 ± 4 N·m)
(2) Put 9S3263 Thread Lock on threads of stud.
Dimension stud must be extended from surface of timing gear housing ... 2.88 in.(73.2 mm)
(3) Torque for three studs ... 20 ± 3 lb. ft.(25 ± 4 N·m)
(4) Put 5P3413 Pipe Sealant on the threads of two studs for installation in the housing. Top of studs to housing ... 1.00 in.(25.4 mm)
NOTE: Cut the gasket between the timing gear cover and the block even with the bottom of the timing gear cover after assembly.
Caterpillar Information System:
3408 VEHICULAR ENGINE Bearings For Connecting Rods And Mains
3408 VEHICULAR ENGINE Crankshaft
3408 VEHICULAR ENGINE Connecting Rod
3408 VEHICULAR ENGINE Pistons And Rings
3408 VEHICULAR ENGINE Cylinder Liner Projection
3408 VEHICULAR ENGINE Cylinder Liners
3408 VEHICULAR ENGINE Cylinder Block
3408 VEHICULAR ENGINE Radiator (Folded Core)
3408 VEHICULAR ENGINE Radiator
3408 VEHICULAR ENGINE Water Temperature Regulator (9N3711)
3408 VEHICULAR ENGINE Water Pump
3408 VEHICULAR ENGINE Engine And Transmission Support Group
3408 VEHICULAR ENGINE Flywheel (6N7098 & 2W6533)
3408 VEHICULAR ENGINE FLYWHEEL RUNOUT
3408 VEHICULAR ENGINE Flywheel Housing
3408 VEHICULAR ENGINE Flywheel Housing Bore
3408 VEHICULAR ENGINE Flywheel Housing Runout
3408 VEHICULAR ENGINE Oil Pan
3408 VEHICULAR ENGINE Drive Gear For The Rear Balancer
3408 VEHICULAR ENGINE Rear Balancer
3408 VEHICULAR ENGINE Rear Gear Group
3408 VEHICULAR ENGINE Air Compressor Drive Group
3408 VEHICULAR ENGINE Fan Drive Group (Earlier-Gear Driven)
3408 VEHICULAR ENGINE Fan Group (Later Engines With Belt Drive)