Usage:
1. Remove the coolant from the cooling system.
2. Loosen clamps (1) and disconnect hoses (2) from engine oil cooler (4). Remove oil filters (5).
3. Remove two bolts (3) and two bolts from behind the oil cooler.
4. Remove oil filter base and engine oil cooler as a unit.
Install Oil Filter Base And Engine Oil Cooler
1. Inspect the O-ring seals in the oil filter base. Install new seals if needed. Put oil on the seals.
2. Put oil filter base and oil cooler in position on the engine. Install the four bolts that hold it in place.
3. Install two oil filters. Connect two hoses.
4. Fill the cooling system to the correct level.
Disassemble Oil Filter Base And Engine Oil Cooler
start by:
a) remove oil filter base and engine oil cooler
1. Remove the bolts that hold cover (1) to base (2). Remove the cover.
2. Remove the three nuts that hold core (3) to the base. Remove the core.
3. Remove the cap and fitting (6), spring (5), and valve (4) from the base.
Assemble Oil Filter Base And Engine Oil Cooler
1. Install the valve, spring, cap and fitting (3) in base (2).
2. Inspect the gasket that goes between the oil filter base and the core. Install a new gasket if needed.
NOTE: The gasket must be installed with point (4) (indexing point) in the position shown.
3. Install the core in the base. Install nuts (1). Tighten the nuts to a torque of 16 ± 2 lb. ft. (21.7 ± 2.7 N·m).
4. Inspect the gasket that goes between the core and cover (6). Install a new gasket if needed.
5. Put the cover in position on the base. Install bolts (5).
end by:
a) install oil filter base and engine oil cooler