Usage:
1. Install the lock pin in the wheel lean bar and the front axle.
To prevent personal injury, do not disconnect any lines from the wheel lean cylinder until the lockpin is installed. |
2. Disconnect oil lines (4) from cylinder (3). Remove the nut and bolt (5). Remove lock (6) from the groove in the wheel lean arm. Remove bolt (8) and retainer (7). Remove bolts (2) and the lock.
3. Fasten a hoist to the cylinder.
Typical Example
4. Remove pin (9) from the wheel lean cylinder (3).
To prevent personal injury, do not remove pin (9) from wheel lean arm (11). |
5. Remove pin (1). Remove wheel lean cylinder (3). Weight is 25 Kg (55 lb.).
NOTE: The following steps are for installation of the wheel lean cylinder.
6. Fasten a hoist to the cylinder (3). Put wheel lean cylinder (3) in position on the front axle. Install pin (1) that holds the cylinder to the front axle. Install the lock and bolts (2).
7. Install pin (9) that holds cylinder (3) to the wheel lean arm (10). Install the lock (6) in the pin (9). Install the bolt and nut (5) that hold lock (6). Tighten the bolt to a torque of 250 ± 14 N·m (185 ± 10 lb.ft.).
8. Install retainer (7) and the bolt (8) on pin (9). Connect oil lines (4) to their correct locations on the cylinder. Remove the lock pin from the wheel lean bar and the front axle.
9. Fill the hydraulic tank with oil to its correct level. See the Operation and Maintenance Manual.