Remanufactured Camshafts And Cam Kits Available For Parts Service
Usage:
3200, 3300, And 3400 Families Of Engines
Reference: Information Release Memo (IRM), REM90-12, PELE0170, "Remanufactured Camshafts And Cam Kits For 3200, 3300, And 3400 Engines". Core Acceptance Guide, SELD0049, "Camshafts And Camshaft Kits".
Remanufactured Camshafts and Cam Kits are available for parts service for the above engine families. Priced at approximately 30 to 50 percent of new, this product program offers another support service for dealer overhauls and qualifies for dealer rebates (U.S. dealers only). Also, Remanufactured Camshafts and Cam Kits are covered by the same factory warranty extended to new parts.
See the Reference for more complete information.
Caterpillar Information System:
1990/12/01 Use Only Stainless Steel Cylinder Liner Shims To Salvage Damaged 4.75" Bore Cylinder Blocks
1990/11/01 New Caterpillar Battery Warranty Statement, SELF5124
1990/11/01 Obsolete Capacitor In VR1 Voltage Regulators
1990/11/01 New 4C6715 Silicone Compound Available For Components Where Centrifugal Force Is Present
1990/11/01 Correct Procedure To Check For Grounds On Woodward 9905 Series, 2301A Control; Correction For Service Manual Module; 2301A Electric Governors (Load Sharing) For Generator Set And Industrial Engines; Form SENR3585-01
1990/11/01 Planetary Housing Requires Two Ball Plugs
1990/11/01 New Relay Added in the 7C9063 and 7C9064 Instrument Panel Groups For Use With New Digital Pyrometers; Special Instruction SEHS9020 Available
1990/11/01 Additional Serviceable Components in Electric Starter Group
1990/11/01 Correct Operation And Alignment Of Parts Eliminates 7W3976 Shaft Failures In 50:1 Barring Device
1990/11/01 New Turbocharger Gas Inlet Housings Used
1990/11/01 New Alternator Drive Pulley Seal Used With New Drive Pulley; Poly-Vee Belt Can Be Installed
1990/11/01 New Cylinder Head Gasket And Higher Cylinder Head Bolt Torque
1990/12/01 New Rear Power Takeoff Clutch Plates Do Not Contain Asbestos
1990/12/01 New Bronze Thrust Plate Used On Center Main Bearing Of Crankshaft Groups
1990/12/01 Service Tips For Piston Cooling Jets (Tubes)
1990/12/01 Correct Handling And Replacement of 3T6962 Pressure Switch Assembly
1990/12/01 New Expansion Tank Used
1990/12/01 New Ether Starting Aid Groups Available
1990/12/01 Field Replacement Of Spacer To Correct Possible Sticking In Woodward 3161 Governor Electric Shutoff Group
1990/12/01 Installation Of Kiene® Valves
1990/12/01 Engine Supervisory System Available For 3600 Family Of Engines
1990/12/01 Correct Procedures For Starting, Stopping And Transporting A Product With A Turbocharged Engine
1990/12/01 New 7E5085 Bushing Replaces Former 2M4314 Bushing In Fuel Injection Pump Groups
1990/12/01 Improved 9W1077 Start Switch Assembly And 7N4160 Heat Start Switch Group