C1.7 and C2.2 Industrial Engines Caterpillar


Product Lifting

Usage:

C1.7 G34


注意

执行任何起吊前,务必检查吊环螺栓和所有其它提升设备有无损坏。 千万不要折弯吊环螺栓和支架。 如果部件损坏,切勿执行设备起吊。 吊环螺栓和支架只能承受张力负荷。 要记住当支承构件和物体之间的角度小于 90° 时,吊环螺栓的承载能力变小。

当必须在某一角度搬移部件时,只能使用具有适当额定载荷的铰链架。


使用起重机搬移重的部件。 使用一个可调的吊粱起吊发动机。 所有的支承构件(链条和钢丝绳)应互相平行。 链条和钢丝绳与被吊物的顶面尽可能保持垂直。

为获得起吊装置时的正确平衡,调节链条长度。

吊耳是为特定的发动机装置设计和安装的。 更换吊耳和/或发动机会使吊耳和吊具不能使用。 如果更换了吊环螺栓和/或发动机,则应确保提供合适的起吊装置。

只对发动机



图 1g03882471
典型示例
(1) 前后吊耳

配备工厂安装散热器的发动机



图 2g06164610
典型示例
(1) 后吊耳
(2) 前吊耳

Caterpillar Information System:

C175 Tier 4 Final Engines for Off-Highway Trucks Engine Cranks but Does Not Start
C9.3B Engines for Caterpillar Built Machines Exhaust Manifold - Remove and Install
C175 Tier 4 Final Engines for Off-Highway Trucks Cat ET Service Error Identifiers
C175 Tier 4 Final Engines for Off-Highway Trucks Exhaust Temperature Is Low
3512B Generator Set Engines with Dynamic Gas Blending Fuel System Operation
3512E Engines Fuel Pump (High Pressure) - Remove and Install
C9.3B Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove and Install
C12.9 Marine Propulsion Engine Cooling System - Test
New Front Window Group Is Now Available for Certain Excavators {7310} New Front Window Group Is Now Available for Certain Excavators {7310}
G3512H and G3516H Generator Set Engines Transfer Gearbox Seal - Install
G3512H and G3516H Generator Set Engines Transfer Gearbox Seal - Remove
C12.9 Marine Propulsion Engine Air Inlet and Exhaust System - Inspect
320D3 and 323D3 Excavators Machine System Specifications Track Roller (Single Flange)
A New 2D Filter is Now Available for C175 Engines {1252} A New 2D Filter is Now Available for C175 Engines {1252}
A New 2D Filter is Now Available for C175 Machine Engines {1252} A New 2D Filter is Now Available for C175 Machine Engines {1252}
C7.1 Marine Propulsion Engine Cold Start Strategy
C7.1 Marine Propulsion Engine Engine Monitoring System (EMS)
C7.1 Marine Propulsion Engine Gauges and Indicators
C7.1 Marine Propulsion Engine Before Starting Engine
G3516 TA Engine Ignition Primary - Test
C1.7 and C2.2 Industrial Engines Fan Clearance - Check
793F and 797F Off-Highway Trucks Power Train Electronic Control System Electronic Control Module (ECM) - Replace
C7.1 Marine Propulsion Engine Cold Weather Starting
C7.1 Marine Propulsion Engine Starting the Engine
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.