A New Exhaust Temperature Module Is Now Used on Certain 3512 and 3516 Engines {1901, 4490, 7451, 7490}
- Engine
- 3512C (S/N: T3P1-378; TKP1-231; T3R1-345; T3S1-235; T3W1-279; T3Y1-200)
- 3516C (S/N: TKR1-257; TKS1-266; TKT1-243; TKX1-205; TKY1-359)
Description Of Change: The new exhaust temperature module will help prevent receiving incorrect exhaust temperatures at low hours when using an incompatible ground fault detection system.
Adaptable To: The following changes are adaptable to the products within the listed serial numbers, and are effective with all products after the listed serial numbers.
The new 234-1644 Engine Monitoring Control Gp replaces the former 343-4631 Exhaust Temperature Module.
Caterpillar Information System:
SCR Retrofit Aftertreatment Product Storage
Marine Selective Catalytic Reduction (SCR) Retrofit Aftertreatment After Stopping Engine
3512E and 3516E Marine Engines Aftercooler - Remove and Install
Radiator Hose Leaks on Certain C1.5 and C2.2 Engines {1353} Radiator Hose Leaks on Certain C1.5 and C2.2 Engines {1353}
New Software Is Now Available For EMCP 4.1 and EMCP 4.2 Displays {7620} New Software Is Now Available For EMCP 4.1 and EMCP 4.2 Displays {7620}
C15 and C18 Engines for Caterpillar Built Machines Electronic Control Wiring Group
3512E and 3516E Marine Engines Turbocharger - Install
G3500H Generator Set Engine Configuration Parameters
C7.1 Engines and Generator Sets ARD Nozzle Heater - Test
C15 and C18 Engines for Caterpillar Built Machines Alternator Mounting
C15 and C18 Engines for Caterpillar Built Machines Turbocharger
C15 and C18 Engines for Caterpillar Built Machines Water Lines
C8.7 and C12.9 Marine Engines Speed Control - Test
G3500J Petroleum Engines Air Lines
C7.1 Marine Engine Transmission Oil Temperature Sensor - Remove and Install
C7.1 Marine Engine Transmission Oil Pressure Sensor - Remove and Install
A New Form is Required When Returning a CRS Head for all Tier 4 Interim and Final Engines {0374, 108U} A New Form is Required When Returning a CRS Head for all Tier 4 Interim and Final Engines {0374, 108U}
G3500J Petroleum Engines Gas Engine Ignition
G3500J Petroleum Engines Gas Engine Ignition
PM820, PM822, and PM825 Cold Planer Rotor Cutter Bits - Inspect/Replace - Drum with Three-Piece Rotor Bits
C7.1 Marine Engine Transmission Oil Cooler - Remove and Install
G3500H Generator Set Engine Start/Stop Control
PM-620 and PM-622 Cold Planer Engine Supplement Engine - Remove and Install
New Engine Software is Now Used on Certain C175 Engines {1920} New Engine Software is Now Used on Certain C175 Engines {1920}