Rocker Arm - Disassemble
Disassembly Procedure
Start By:
- Remove valve mechanism cover.
- Remove fuel manifold (rail).
- Remove the rocker arm and shaft.
- Remove nuts (1), buttons (3), and screws (2) .
Show/hide table
Illustration 1 | g03871946 |
Note: Place an identification mark on all components for assembly purposes.
- Remove rocker arms (5), rocker arms (6) from rocker arm shaft (4) .
Caterpillar Information System:
C7.1 Commercial Marine Engine Valve Lash Is Excessive
C7.1 Commercial Marine Engine Sea Water Pump Pressure Is Low
C7.1 Commercial Marine Engine Power Is Intermittently Low or Power Cutout Is Intermittent
C7.1 Commercial Marine Engine Oil Temperature Is High
Bench Test Procedure for Hydraulic Piston Pumps{5070} Bench Test Procedure for Hydraulic Piston Pumps{5070}
Bench Test Procedure for Hydraulic Piston Pumps {5070} Bench Test Procedure for Hydraulic Piston Pumps {5070}
C7.1 Marine Engine Oil Pressure Is Low
2015/09/04 Improved Crankshaft Rear Seals Are Used on Certain C13 Commercial Engines {1161}
2015/08/07 Some Turbochargers and Turbocharger Cartridges are Difficult to Spin Before Lubricating the Center Housing for Certain Engine Applications {1052, 1053}
C280 Marine Engines Relay - Test - Power Mode Relay
C7.1 Commercial Marine Engine Oil Contains Coolant
XQ2000 Power Module Refill Capacities
C8.7 Marine Engine Rocker Arm - Assemble
High-Pressure Fuel Pumps Are Failing on Certain C9 and C9.3 Engines {1714} High-Pressure Fuel Pumps Are Failing on Certain C9 and C9.3 Engines {1714}
C13 Industrial Engine Selective Catalytic Reduction Warning System
C280 Marine Engines Electrical Power Supply - Test
C15 and C18 Industrial Engines Engine Stopping
C8.7 Marine Engine Engine Oil Pump - Remove and Install
C280 Marine Engines Engine Speed/Timing Sensor
C280 Marine Engines Bypass Valve - Compressed Air
C18 Marine Engine Maintenance Interval Schedule
C9 Marine Generator Set Maintenance Interval Schedule
2015/08/07 A New Fuel Line Is Available for Certain C7.1 Engines {1274}
2015/08/21 A New Air Inlet Elbow, Air Inlet Lines, and Fuel Lines Are Used for Certain G3500C and G3500E Engines {1071, 1087, 1274}