Engine Oil Pressure Sensor - Remove and Install
- Disconnect harness assembly (1) and remove engine oil pressure sensor (2).
Show/hide table
Illustration 1 | g03063307 |
The engine oil filter has been removed for photographic purposes. |
- Install engine oil pressure sensor (2) in the reverse order of removal.
- Tighten engine oil pressure sensor (2) to a torque of
10 ± 2 N·m (89 ± 18 lb in) .
- Tighten engine oil pressure sensor (2) to a torque of
Caterpillar Information System:
C18 Marine Engines Coolant Temperature Sensor - Remove and Install - Jacket Water
C18 Marine Engines Coolant Level Sensor - Remove and Install - SCAC
C18 Marine Engines Coolant Level Sensor - Remove and Install - Jacket Water
C3.3B and C3.8 Engines for Caterpillar Built Machines Oil Consumption Is Excessive
C18 Marine Engines Crankshaft Position Sensor - Remove and Install
C18 Marine Engines Camshaft Position Sensor - Remove and Install
C18 Marine Engines Atmospheric Pressure Sensor - Remove and Install
C3.3B and C3.8 Engines for Caterpillar Built Machines Fuel Consumption Is Excessive
C3.3B and C3.8 Engines for Caterpillar Built Machines Engine Shutdown Occurs Intermittently
C3.3B and C3.8 Engines for Caterpillar Built Machines Cooling Fan Is Always ON
3500 Marine Engines Camshaft Bearing Position
Torque Multipliers, Models 1U-7293, 6V-7820 and 6V-6080{0599, 0765} Torque Multipliers, Models 1U-7293, 6V-7820 and 6V-6080{0599, 0765}
C3.3B and C3.8 Engines for Caterpillar Built Machines Oil Contains Coolant
C18 Marine Engines Engine Oil Temperature Sensor - Remove and Install
C18 Marine Engines Fuel Pressure Sensor - Remove and Install
C18 Marine Engines Fuel Temperature Sensor - Remove and Install
C18 Marine Engines Inlet Air Temperature Sensor - Remove and Install
C18 Marine Engines Electronic Control Module - Remove and Install
C3.3B and C3.8 Engines for Caterpillar Built Machines Oil Contains Fuel
C3.3B and C3.8 Engines for Caterpillar Built Machines Valve Lash Is Excessive
C280-12 and C280–16 Marine Engines Exhaust Manifold Shield - Remove and Install
2015/09/28 A Floating Valve Bridge and New Cylinder Head Groups Are Used for Certain CG137 and G3400 Engines {1100, 1102, 1121, 1123, 1209}
3512C and 3516C Marine Engines Crankcase Pressure
C3.3B and C3.8 Engines for Caterpillar Built Machines Sensor Signal (Analog, Passive) - Test