Rocker Arm and Shaft - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 124-2946 | Lifting Bracket | 1 |
Start By:
- Remove the valve mechanism cover.
- Remove bolts (1).
- Remove rocker arms and shaft (2) as a unit with Tooling (A).
Show/hide table
Illustration 1 | g01033395 |
- Install rocker arms and shaft (2) in the reverse order of removal.
- Apply clean engine oil to the underside of the bolt heads, for bolts (1), prior to installation.
Show/hide table
Illustration 2 g03052218 - Use the tightening sequence in Illustration 2 to tighten bolts (1) to a torque of
50 ± 5 N·m (37 ± 4 lb ft) . Turn bolts (1) an additional 45° ± 5°.
- Apply clean engine oil to the underside of the bolt heads, for bolts (1), prior to installation.
- Adjust the electronic unit injectors. Refer to Testing and Adjusting, "Electronic Unit Injector - Adjust".
Caterpillar Information System:
G3306B Generator Sets Generator Winding Insulation - Test
G3500 Generator Sets Generator Winding - Test
C18 Marine Engines Valve Mechanism Cover Base - Remove and Install
C7.1 Industrial Engine Power Sources
C7.1 Industrial Engine Electronic Control System
C18 Marine Engines Valve Mechanism Cover - Remove and Install
3500B Generator Sets Generator Bearing Temperature - Test/Record
C7.1 Industrial Engine Fuel Injection
C7.1 Industrial Engine Air Inlet and Exhaust System - Single Turbocharger
C7.1 Industrial Engine Turbocharger - Inspect - Single Turbocharger
2012/09/13 A New Turbocharger Housing is Used on Certain 3512 Engines {1052, 1065}
C7.1 Industrial Engine Turbocharger - Inspect - Series Turbochargers
3512C HD SR500 Generator Sets Rotating Rectifier - Inspect/Test
Core Plugs in C27 and C32 Remanufactured Long Blocks and Engine Cylinder Heads Can Be Installed At An Improper Depth{1100, 1201} Core Plugs in C27 and C32 Remanufactured Long Blocks and Engine Cylinder Heads Can Be Installed At An Improper Depth{1100, 1201}
C18 Marine Engines Cylinder Head - Remove and Install
G3500 Generator Sets Space Heater - Test
C3.3B and C3.8 Engines for Caterpillar Built Machines Cat ET Service Features - DEF Dosing System Test
2012/08/08 A New Aftercooler Group is Used on Certain C175 Engines {1063}
C18 Marine Engines Camshaft - Remove and Install
C18 Marine Engines Camshaft Gear - Remove and Install
C18 Marine Engines Camshaft Bearings - Remove and Install
G3500 Generator Sets Generator Set Vibration - Inspect
G3500 Generator Sets Inlet Air System - Check
3500 Engines with EUI Option Aftercooler