Alternator Problem - Charging Problem and/or Noisy Operation
可能原因
- 交流发电机
- 充电电路
建议的措施
注: 下面以概率的先后顺序列出了这些步骤。 依次完成这些步骤。
Show/hide table
故障诊断与排除测试步骤     | 数值     | 结果     |
---|---|---|
1. 交流发动机传动带的状况 A. 检查交流发动机传动带的状况。 B. 检查传动带张力。 如果发动机配备传动带自动张紧装置,则检查传动带自动张紧装置。 过大的皮带张力可能会导致交流发电机损坏。     |
传动带     |
结果:交流发电机驱动皮带处理良好状态且皮带张力正确。 转至测试步骤 2。 结果:交流发电机驱动皮带未处于良好状态且皮带张力不当。 修理:如果交流发电机传动带磨损或损坏,则更换传动带。 参考拆解和装配以了解正确步骤。 如有必要,更换传动带自动张紧装置。 参考拆解和装配以了解正确步骤。     |
2. 交流发电机传动皮带轮的状况 A. 检查交流发电机传动皮带轮的状况。 检查皮带轮中有无驱动皮带磨损造成的深槽。 检查并确认皮带轮螺母没有松动。     |
交流发电机驱动皮带轮     |
结果:交流发电机驱动皮带轮发生过度磨损。 修理:更换皮带轮。 结果:交流发电机驱动皮带轮螺母松动。 修理:拧紧螺母。 结果:交流发电机驱动皮带轮未发生过度磨损。 转至测试步骤 3。     |
3. 交流发电机轴承的磨损 A. 检查交流发电机轴承有无磨损迹象。     |
交流发电机轴承     |
结果:交流发电机轴承正常。 继续测试步骤 4。 结果:交流发电机轴承异常。 修理:根据需要,修理或更换交流发电机。 参考拆解和装配以了解正确步骤。     |
4. 交流发电机或调节器的工作状况 A. 确认交流发电机或电压调节器工作正常。 有关正确的测试程序,请参阅专门说明书, REHS0354, "充电系统故障诊断和排除"。     |
调节器和交流发电机     |
结果:调节器和交流发电机正常工作。 继续测试步骤 5。 结果:调节器和交流发电机不正常工作。 修理:根据需要修理或更换交流发电机和调节器。 参考拆解和装配以了解正确步骤。     |
5. 检查充电电路 A. 检查蓄电池电缆、配线和充电电路中的连接。     |
充电电路     |
结果:充电电路不正常工作。 修理:清洁并紧固所有连接。 更换所有存在故障的零件。     |
Caterpillar Information System:
C13, C15, and C18 Tier 4 Final Engines Acceleration Is Poor or Throttle Response Is Poor
C13, C15, and C18 Tier 4 Final Engines Diagnostic Trouble Codes
C13, C15, and C18 Tier 4 Final Engines Configuration Parameters
C13, C15, and C18 Tier 4 Final Engines Electrical Connectors
2012/02/10 Improved Fuel Priming Pump Groups and Fuel Pump Groups Are Used on Certain Tier 4 Interim Industrial Engines {1256, 1258}
C175-16 Marine Engine Pistons and Connecting Rods
C13, C15, and C18 Tier 4 Final Engines Diagnostic Capabilities
C13, C15, and C18 Tier 4 Final Engines Engine Monitoring System
C13, C15, and C18 Tier 4 Final Engines Diesel Particulate Filter Regeneration
C13, C15, and C18 Tier 4 Final Engines Component Location
C13, C15, and C18 Tier 4 Final Engines System Overview
3516B Generator Set Engines with Dynamic Gas Blending Service Information Report
C175-16 Marine Engine Pistons, Liners, and Connecting Rods
3512C and 3516C Marine Propulsion Engines Component Location
C175-16 Marine Engine Crankshaft Main Bearings
2012/02/07 Cylinder Head Blanking Plug on Certain C3.4 Engines {1100}
C175-16 Locomotive Engine Fuel Injection Pump
C13, C15, and C18 Tier 4 Final Engines ARD Is Disabled
3516B Generator Set Engines with Dynamic Gas Blending Battery Problem
C13, C15, and C18 Tier 4 Final Engines Coolant Contains Fuel
C13, C15, and C18 Tier 4 Final Engines Coolant Contains Oil
C13, C15, and C18 Tier 4 Final Engines Coolant Level Is Low
C175-16 Marine Engine Turbocharger
C13, C15, and C18 Tier 4 Final Engines Coolant Temperature Is High