Vibration Damper and Pulley - Remove and Install
拆卸步骤
- 拆下螺母 (1) 、皮带轮 (3) 和皮带轮 (4) 。
Show/hide table
 | |
| 图 1 | g00787626 |
- 将减振器 (2) 移出约 25.4 mm (1.00 in)。 将起重机固定到减振器上。 拆下减振器 (2) 。 减振器的重量约为 36 kg (80 lb)。
- 拆下螺栓 (5) 和转接接头 (6) 。 如需更换，拆下螺柱 (7) 。
Show/hide table
 | |
| 图 2 | g00787632 |
安装步骤
- 按与拆卸相反的顺序安装减振器 (2) 和皮带轮 (3) 。
- 将螺柱 (7) 拧紧至至扭矩为 54 ± 7 N·m (40 ± 5 lb ft)。
- 拧紧螺栓 (5) 至扭矩为 136 ± 14 N·m (100 ± 10 lb ft)。
Caterpillar Information System:
CG137-08 and CG137-12 Generator Sets Valve Cover
C280 Marine Engines Nitrogen Oxide Sensor (Exhaust Pipe Out)
C280 Marine Engines Nitrogen Oxide Sensor (Engine Exhaust Out)
3516C Generator Set Engines Nozzle (DEF)
3516C Generator Set Engines Temperature Sensor (Exhaust)
C9.3 Tier 4 Final Engines Inlet Air Temperature Sensor
C9.3 Engines for Caterpillar Built Machines Boost Pressure Sensor
C9.3 Tier 4 Final Engines Engine Oil Pressure Sensor
C9.3 Engines for Caterpillar Built Machines Fuel Pressure Sensor
Photo Request Instructions for Identifying and Repairing 50MT Starter Motor Problems{1453} Photo Request Instructions for Identifying and Repairing 50MT Starter Motor Problems{1453}
C15 Engines for Combat and Tactical Vehicles Electronic Control System Components
CG137-08 and CG137-12 Engines Engine Oil Pan - Remove and Install - G3412B
CG137-08 and CG137-12 Engines Flywheel - Remove and Install
C4.4 Marine Generator Set Engine Operation
CG137-08 and CG137-12 Engines Flywheel Housing - Remove and Install
C15 Engines for Combat and Tactical Vehicles Air Inlet and Exhaust System
C13, C15, and C18 Tier 4 Final Engines Speed/Timing Sensor
G3516 Engines Engine Speed/Timing Sensor
G3516 Engines Engine Speed Sensor
CG137-08 and CG137-12 Generator Sets Stub Shaft (Rear)
CG137-08 and CG137-12 Generator Sets Flywheel
C9.3 Tier 4 Final Engines Flywheel Housing
C13, C15, and C18 Tier 4 Final Engines Pressure Sensor (Exhaust Differential)
3516C Generator Set Engines Catalytic Converter Sensor