Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
在完成下列工序之前，请先完成操作和保养手册, "发动机空气滤清器维护指示器 - 检查"中叙述的步骤以及操作和保养手册, "发动机空气预滤器检查/清洗"工序（如有配备）。
Show/hide table
| 注意 |
|---|
|
未安装空气滤清器滤芯切勿运转发动机。 空气滤清器滤芯损坏时也决不能运转发动机。 不要使用褶纸、垫圈或密封件损坏的滤芯。 污物进入发动机会造成发动机零部件的早期磨损和损坏。 空气滤清器滤芯有助于防止空气中的碎屑进入进气口。 |
Show/hide table
| 注意 |
|---|
|
在发动机运转时切勿保养空气滤清器滤芯，因为这样会使污物进入发动机。 |
Show/hide table
| |
| 图 1 | g00310664 |
|
(1) 空气滤清器盖
(2) 空气滤清器滤芯 (3) 进气口 | |
- 拆除空气滤清器盖 (1)，然后拆除空气滤清器滤芯 (2)。
- 用胶带或干净的布封堵进气口 (3) 以防碎屑进入进气口。
- 清洁空气滤清器盖 (1) 内部。 把固定空气滤清器芯的壳体擦净。
- 检查替换滤芯的以下各项：损伤, 灰尘 和 碎屑。
- 把进气口上的封堵去掉。
- 安装一个干净的、完好无损的空气滤清器滤芯 (2)。
- 安装空气滤清器盖 (1) 。
- 复位空气滤清器维护指示器。
Caterpillar Information System:
C7.1 (Mech) Industrial Engine Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
XQP150 Rental Generator Set Belts - Inspect/Adjust/Replace
C27 and C32 Engines for Caterpillar Built Machines Piston and Rings
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Solenoid Valve (Proportional Reducing) - Calibrate - Flow Limit Valves
C13 Tier 4 Final Engines Air Cleaner
C13 Tier 4 Final Engines Air Cleaner
UPSB220 Uninterruptible Power Supply Single UPS Startup and Shutdown
UPSB220 Uninterruptible Power Supply Single UPS Connection
UPSB220 Uninterruptible Power Supply Parallel UPS Startup and Shutdown
UPSB220 Uninterruptible Power Supply Parallel UPS Connection
UPSB220 Uninterruptible Power Supply Modes Of Operation
UPSB220 Uninterruptible Power Supply Maintenance Interval Schedule
C3.4B Industrial Engine Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
3516B Marine Auxiliary Engine Cat Data Link - Test
C27 and C32 Engines Exhaust Elbow - Remove and Install - Clean Emissions Module Inlet
C15 and C18 Industrial Engines Pistons and Connecting Rods - Remove and Install
312E, 312F, 313F, 316E, 316F, 318E, 318F, 320E, 320F, 323E, 323F, 324E, 325F, 326F, 329E, 329F, 330F, 335F, 336E, 336F, 340F, 349E, 349F, 352F, 374F and 390F Excavators and 336E MHPU and 349E MHPU Mobile Hydraulic Power Units Air Conditioning and Hea Pressure Switch (Refrigerant Pressure Cutoff)
2010/12/08 An Improvement has been Made to Reduce the Amount of Radial Play of the Front Linkage Pin on Certain Excavators {6501, 6502, 6513}
C15 and C18 Engines for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - Differential Pressure
C15 and C18 Engines for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - Outlet Pressure
Installing an Automatic Stationary Regeneration Switch on Certain On-highway Engines{108F, 7332} Installing an Automatic Stationary Regeneration Switch on Certain On-highway Engines{108F, 7332}
C27 Petroleum Engine Inlet and Exhaust Valve Springs - Remove and Install
C4.4 Industrial Engine Aftercooler Core - Inspect
CG137-08 and CG137-12 Industrial Engines Electronic Control System Components