Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Show/hide table
冷却系统的冷却液添加剂含碱。 要避免与皮肤和眼睛接触,以免造成人身伤害。 不要饮用冷却液添加剂。 |
注: Caterpillar 推荐进行 S·O·S 定期冷却液分析(1 级)。
Show/hide table
注意 |
---|
不要超过推荐的6%的补充用冷却液添加剂的浓度。 |
用 8T-5296 冷却液调节器测试包 来测试补充用冷却液添加剂(SCA)的浓度。 遵照随该工具包提供的说明书进行测试。
Show/hide table
注意 |
---|
不要超过推荐的8%的冷却液补充添加剂的浓度。 |
用 8T-5296 冷却液调节器测试包 来测试补充用冷却液添加剂(SCA)的浓度。 使用以下用法说明:
- 将冷却液吸入注射器到 "1.0 ml" 标记处。
- 将 1.0 ml 的冷却液液样从注射器注入到空的混合瓶中。
- 向混合瓶中加入自来水,使液位升至 "10 ml"。 盖上瓶盖,然后摇晃瓶子。
- 向混合瓶中加 2 至 3 滴"亚硝酸盐指示剂溶液 B"。 转动瓶子,以充分混合该溶液。
- 向混合瓶中加一滴"亚硝酸盐测试剂溶液 A"。 转动瓶子,以充分混合该溶液。
- 重复步骤 5,直到溶液从红色变为浅灰色、绿色或蓝色。 记录下引起颜色改变所需的"亚硝酸盐测试剂溶液 A" 的滴数。
- 用表 1来解释滴数结果。
Show/hide table
表 1 滴数 补充用冷却液添加剂(SCA)浓度 保养
需要量小于 25 小于推荐的补充用冷却液添加剂 (SCA) 浓度 添加补充用冷却液添加剂 (SCA)。
重新测试冷却液。25 至 30 推荐的补充用冷却液添加剂(SCA)浓度 无 大于 30 大于推荐的补充用冷却液添加剂 (SCA) 浓度 放掉冷却液。
只加水替代放掉的冷却液
重新测试冷却液。
Show/hide table
加压的系统: 热的冷却液能造成严重的烫伤。 在发动机停机,等待冷却系统部件冷却下来后再打开冷却系统加注口盖。 缓慢松开冷却系统加注口盖,以释放掉所有压力。 |
- 缓慢拆下冷却系统加注口盖。
注: 一定要遵守当地的法规来处置液体。
- 如有必要,放掉部分冷却液,以便留出加入 SCA 的空间。
Show/hide table
注意 冷却液补充添加剂过浓会在冷却系统高温表面形成沉积物,降低发动机的传热特性。 降低传热会引起气缸盖或其它高温零部件开裂。
冷却液补充添加剂过浓还会引起散热器管堵塞、过热和/或加速水泵水封磨损。
不要超过冷却液补充添加剂浓度的推荐量。
- 添加适量的 SCA。 SCA的浓度根据所使用的冷却液类型而有所不同。 请参阅本操作和保养手册 , "再加注容量和建议 "专题,以确定适当的添加量。
- 清洁冷却系统加注口盖。 安装冷却系统加注口盖。
Caterpillar Information System:
C4.4 (Mech) Marine Generator Set MCS-3 Coolant Sample (Level 2) - Obtain
C4.4 (Mech) Marine Generator Set MCS-3 Coolant Sample (Level 1) - Obtain
C4.4 (Mech) Marine Generator Set MCS-3 Coolant Level - Check
C7.1 Marine Generator Set Coolant Extender (ELC) - Add
C4.4 (Mech) Marine Generator Set MCS-3 Coolant (ELC) - Change
C4.4 (Mech) Marine Generator Set MCS-3 Product Lifting
C4.4 (Mech) Marine Generator Set MCS-3 Product Installation
C4.4 (Mech) Marine Generator Set MCS-3 Reference Information
C9.3 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Fuel System Primary Filter (Water Separator) Element - Replace
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Fuel System Secondary Filter - Replace
C11, C13, C15, and C18 Industrial Engines Engine Overcrank Occurrence
C4.4 (Mech) Marine Generator Set MCS-3 Coolant Temperature Regulator - Replace
C4.4 (Mech) Marine Generator Set MCS-3 Engine - Clean
C4.4 (Mech) Marine Generator Set MCS-3 Water Pump - Inspect
C4.4 (Mech) Marine Generator Set MCS-3 Walk-Around Inspection
C4.4 (Mech) Marine Generator Set MCS-3 Turbocharger - Inspect
C4.4 (Mech) Marine Generator Set MCS-3 Starting Motor - Inspect
C4.4 (Mech) Marine Generator Set MCS-3 Standby Generator Set Maintenance Recommendations
C4.4 (Mech) Marine Generator Set MCS-3 Sea Water Strainer - Clean/Inspect
C15 and C18 Petroleum Generator Sets Rotating Rectifier - Inspect/Test
C4.4 (Mech) Marine Generator Set MCS-3 Rotating Rectifier - Check
C4.4 (Mech) Marine Generator Set MCS-3 Overhaul Considerations
C4.4 (Mech) Marine Generator Set MCS-3 Hoses and Clamps - Inspect/Replace