Stator Winding Temperature - Test
Některé generátory jsou vybaveny volitelnými odporovými detektory teploty (RTD) s odporem 100 ohm. Když se očekává vysoká teplota vinutí statoru, změřte teplotu. Pokud je generátor vybaven odporovými detektory teploty, jsou detektory instalovány v drážkách hlavní kotvy elektromotoru (statoru). Detektory se používají s vybavením, které je k dispozici z výrobního závodu. Toto vinutí se používá k měření teploty vinutí hlavní kotvy.
Caterpillar Information System:
PMG3516 Power Module Rotating Rectifier - Inspect/Test
G3304B and G3306B Engines Inlet Air System - Check
C175-16 PETROLEUM ENGINES Crankshaft - Install
G3500 Engines Engine Valve Lash and Bridge - Check
C18 Generator Set Engine Mounts - Inspect
G3304B and G3306B Engines Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
G3406 Engine Cylinder Pressure - Test/Record
G3406 Engine Coolant Sample (Level 2) - Obtain
C175-16 PETROLEUM ENGINES Crankshaft - Remove
G3500 Generator Sets Coolant Sample (Level 1) - Obtain
G3500H 60Hz Generator Sets Coolant Level - Check
G3500 Generator Sets Coolant (NGEC) - Change
G3500 Generator Sets Varistor - Check
349F and 352F Excavators Lifting and Tying Down the Machine
2010/10/22 New Rocker Arm Assemblies Are Available on Some Commercial Engines {1123}
2010/02/22 New Rocker Arm Assemblies Are Available on Some Truck Engines {1123}
2013/02/08 A Modified Procedure Is Now Used to Seal the Mating Surfaces of the Cylinder Block and the Gasket on Certain Truck Engines {1124, 1201, 7555}
EMCP4.1/EMCP4.2 Data Link
Proper Installation of Braided Steel Hoses{7554} Proper Installation of Braided Steel Hoses{7554}
C175-16 PETROLEUM ENGINES Engine Oil Pump - Disassemble
EMCP4.1/EMCP4.2 MUI Engine Monitoring and Control
C175-16 PETROLEUM ENGINES Engine Oil Pump - Assemble
EMCP4.1/EMCP4.2 Electronic Control Module (Engine)
EMCP4.1/EMCP4.2 Password Entry