Illustration 1 | g01948663 |
Note: Lubricate the gear pump group with clean oil before you operate. The gear pump group must rotate freely by using your hand.
(1) Section for transmission lubrication
- Rotation ... Counterclockwise
- Test speed ... 1800 rpm
- Test pressure ...
480 kPa (70 psi) - Minimum flow ...
566.0 L/min (149.5 US gpm) - Test speed ... 1800 rpm
(2) Section for torque converter charging
- Rotation ... Counterclockwise
- Test speed ... 1800 rpm
- Test pressure ...
930 kPa (135 psi) - Minimum flow ...
584.0 L/min (154.3 US gpm) - Test speed ... 1800 rpm
(B) Diameter of the new shaft of the gear ...
Note: Make sure that the gear (3) slides freely on two woodruff keys (4).
Illustration 2 | g01948664 |
Detail C |
(G) Location of joints of six sleeve bearings from the vertical centerline ... 30 ± 15 degrees
(H) Distance from end of four dowels to the face of the oil pump body assembly (7) ...
(J) Installation depth of two bolt dampers (6) into the oil pump body assembly ...
(K) Installation depth of two sleeve bearings into the oil pump body assembly ...
(5) 262-0562 Sleeve Bearing
- Inside diameter ...
50.918 ± 0.040 mm (2.0046 ± 0.0016 inch) - Outside diameter ...
55.732 ± 0.025 mm (2.1942 ± 0.0010 inch) - Outside diameter ...
Illustration 3 | g01948665 |
Detail D |
(M) Installation depth of four sleeve bearings into the cover assembly (9) ...
(N) Distance from end of the sleeve (8) to the face of the cover assembly ...
Illustration 4 | g01948666 |
Detail E (10) Cover assembly |
(9) 154-1986 Sleeve Bearing
- Outside diameter ...
57.226 ± 0.013 mm (2.2530 ± 0.0005 inch) - Thickness ...
3.366 ± 0.064 mm (0.1325 ± 0.0025 inch) - Thickness ...