Electronic Modular Control Panel II+ Paralleling (EMCP II+P) Caterpillar

Replacement Procedure

1. The new GSC+P must be reprogrammed after the new GSC+P is installed. If the GSC+P that is being replaced is functional, then make a note of the following items: value of the hour meter, all engine setpoints and any spare inputs/outputs. Refer to System Operation, "Engine/Generator Setpoint Viewing OP2-0" and System Operation, "Protective Relaying Setpoint Viewing OP2-1".

2. Shut down the engine. Remove the positive lead wire from the battery.

3. Remove the harness connector from the GSC+P. A 4 mm hex wrench is required to turn the fastening screw.

4. Make sure that all wires at the terminal strips are marked with the respective terminal location for reassembly. Remove all wires from the terminals and from the posts of the relay module.

5. Remove the six nuts that fasten the GSC+P to the front panel. Remove the GSC+P.

6. Place the new GSC+P in the front panel. Install the six nuts. Tighten the nuts.

7. Reconnect the harness connector to the GSC+P. Reconnect all the wires to the terminals of the relay module that were removed. Reconnect the positive lead wire to the battery. If necessary, refer to the Generator Set Wiring Diagram Testing And Adjusting, "Schematics And Wiring Diagrams".

8. Reprogram the setpoints, the spare inputs/outputs, the hour meter, the voltmeter/ammeter and the AC offset adjustment. Refer to System Operation, "Service Mode". Use the values from the original GSC+P. Refer to Step 1.