Machine Operating Temperature Range
The standard machine configuration is intended for use within an ambient temperature range of
Machine Operating Altitude Range
If the machine is used at elevations, higher than
Only operate the machine while you are in a seat. The seat belt must be fastened while you operate the machine. Only operate the controls while the engine is running.
Before you move the machine, make sure that no one will be endangered.
While you operate the machine slowly in an open area, check for proper operation of all controls and all protective devices.
Do not allow riders on the machine unless the machine has the following equipment:
- Additional seat
- Additional seat belt
- Roll over Protective Structure (ROPS)
Never use the work tool for a platform.
Note any needed repairs during machine operation. Report any needed repairs.
When the machine is on an upward slope, avoid dumping the machine. The machine could tip backward.
Avoid any conditions that can lead to tipping the machine. The machine can tip when you work on hills, on banks and on slopes. Also, the machine can tip when you cross ditches, ridges, or other unexpected obstacles.
Avoid operating the machine across the slope. When possible, operate the machine up the slopes and down the slopes.
Maintain control of the machine. Do not load the machine beyond the machine capacity.
Never straddle a wire cable. Never allow other personnel to straddle a wire cable.
Know the maximum dimensions of your machine.
Always keep the Rollover Protective Structure (ROPS) installed during machine operation.
Always anticipate the grade and select the proper gear range for the grade.
For dump body machines, lower the dump body completely before travel. Keep the hoist control in the FLOAT position during travel.
For ejector body machines, retract the ejector plate completely and raise the tailgate completely before travel. Keep the hoist control in the first HOLD position during travel.
When the machine is being loaded, stay in the operator station of the machine.
Obey all road signs.
A signalman should be present, when you move the machine in a building or out of a building.