V-Belt - Test
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Name     | Qty     |
A     | 144-0235     | Belt Tension Gauge     | 1     |
Show/hide table
Belt Tension Chart     | |||||||||
---|---|---|---|---|---|---|---|---|---|
Size of Belt     | Width of Belt     | Gauge Reading     | |||||||
Initial Belt Tension (1) | Used Belt Tension (2)     | ||||||||
1/2     | 13.89 mm (0.547 Inch)     |
535 N (120 lb)     |
355 N (80 lb)     |
||||||
Measure the tension of the belt that is farthest from the engine.     |
Show/hide table
( 1 ) | Initial Belt Tension refers to a new belt. |
( 2 ) | Used Belt Tension refers to a belt that has been in operation for 30 minutes or more at the rated speed. |
- Check the belts for wear and check the belts for damage.
- Fit Tooling (A) at the center of the longest free length of the belt and check the tension on both belts. Check and adjust the tension on the tightest belt. To adjust the belt tension, refer to Disassembly and Assembly, "Alternator - Install".
Show/hide table
Illustration 1 | g01241384 |
Typical example (A) 144-0235 Belt Tension Gauge |
Caterpillar Information System:
C3.3 Industrial Engine Glow Plugs - Test
C3.3 Industrial Engine Electric Starting System - Test
C3.3 Industrial Engine Alternator - Test
C27 and C32 Generator Set Engines Vibration Damper and Pulley
2007/08/13 New Engine Vision Software Is Now Available {7490, 7620}
345D, 349D and 349D2 Excavators Fuel System - Prime
Reuse and Salvage for 3114, 3116, and 3126 Engine Series Cylinder Blocks {1201} Reuse and Salvage for 3114, 3116, and 3126 Engine Series Cylinder Blocks {1201}
2007/10/01 New Gas Engines Meet New Emissions Ratings {1278, 191N}
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 3463 - FMI 2
G3408C and G3412C Engines Fan Drive
C32 Marine Auxiliary Engines Electrical Power Supply - Test
C32 Marine Auxiliary Engines Speed Control (Switch) - Test
C3.3 Industrial Engine Valve Guide - Inspect
C3.3 Industrial Engine Engine Oil Pressure - Test
C1.7, C1.8, and C2.4 Tier 4 Interim and EU Stage 3A Engines for Caterpillar Built Machines Engine Oil Pump - Inspect
C3.3 Industrial Engine Excessive Bearing Wear - Inspect
C3.3 Industrial Engine Excessive Engine Oil Consumption - Inspect
C3.3 Industrial Engine Increased Engine Oil Temperature - Inspect
C3.3 Industrial Engine Cooling System - Check - Overheating
C3.3 Industrial Engine Cooling System - Inspect
C3.3 Industrial Engine Cooling System - Test
C3.3 Industrial Engine Connecting Rod - Inspect
C3.3 Industrial Engine Piston Height - Inspect
C6.6 Engines for Caterpillar Built Machines Electronic Unit Injector - Remove