Glow Plugs - Test
Continuity Check of the Glow Plugs
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Name     | Qty     |
A     | 6V-7070     | Digital Multimeter     | 1     |
B     | 225-8266     | Ammeter     | 1     |
The following test will check the continuity of the glow plugs.
- Disconnect the power supply from the bus bar and then remove the bus bar.
- Set Tooling (A) in order to check continuity (resistance). Turn the audible signal on Tooling (A) to the ON position.
- Place one probe on the connection for the glow plug and the other probe to a suitable ground. Tooling (A) should make an audible sound. Replace the glow plug if there is no continuity.
- Check the continuity on all the glow plugs.
Checking The Operation of The Glow Plug
The following test will check the operation of the glow plugs.
- Disconnect the power supply from the bus bar and then remove the bus bar.
- Connect the power supply to only one glow plug.
- Place Tooling (B) on the power supply wire.
- Turn the switch to the ON position in order to activate the glow plug.
Show/hide table
Table 2 12 Volt System     Amp     Time (sec)     30     Initial     21     4     14     8     10     20     9     60    
- Repeat the procedure in order to check the reading on all of the glow plugs.
- If there is no reading on Tooling (B) check the electrical connections. If the reading on Tooling (B) is low or if the reading is zero, replace the faulty glow plug.
Caterpillar Information System:
C3.3 Industrial Engine Electric Starting System - Test
C3.3 Industrial Engine Alternator - Test
C27 and C32 Generator Set Engines Vibration Damper and Pulley
2007/08/13 New Engine Vision Software Is Now Available {7490, 7620}
345D, 349D and 349D2 Excavators Fuel System - Prime
Reuse and Salvage for 3114, 3116, and 3126 Engine Series Cylinder Blocks {1201} Reuse and Salvage for 3114, 3116, and 3126 Engine Series Cylinder Blocks {1201}
2007/10/01 New Gas Engines Meet New Emissions Ratings {1278, 191N}
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission, SPN 3463 - FMI 2
G3408C and G3412C Engines Fan Drive
C32 Marine Auxiliary Engines Electrical Power Supply - Test
C32 Marine Auxiliary Engines Speed Control (Switch) - Test
C3.3 Industrial Engine Hoses and Clamps - Inspect/Replace
C3.3 Industrial Engine V-Belt - Test
C3.3 Industrial Engine Valve Guide - Inspect
C3.3 Industrial Engine Engine Oil Pressure - Test
C1.7, C1.8, and C2.4 Tier 4 Interim and EU Stage 3A Engines for Caterpillar Built Machines Engine Oil Pump - Inspect
C3.3 Industrial Engine Excessive Bearing Wear - Inspect
C3.3 Industrial Engine Excessive Engine Oil Consumption - Inspect
C3.3 Industrial Engine Increased Engine Oil Temperature - Inspect
C3.3 Industrial Engine Cooling System - Check - Overheating
C3.3 Industrial Engine Cooling System - Inspect
C3.3 Industrial Engine Cooling System - Test
C3.3 Industrial Engine Connecting Rod - Inspect
C3.3 Industrial Engine Piston Height - Inspect