Auxiliary Water Pump
Show/hide table
Illustration 1 | g01378565 |
(1) O-ring seal ... Lubricate the bore lightly with the lubricant that is being sealed.
(2) Use the following procedure to tighten the bolt.
- Tighten the bolt.
Torque ... 55 ± 7 N·m (41 ± 5 lb ft)
- Lightly tap the water pump drive gear with a soft faced hammer.
- Tighten the bolt again.
Torque ... 55 ± 7 N·m (41 ± 5 lb ft)
Show/hide table
Illustration 2 | g01378644 |
(4) Apply 4C-9506 Retaining compound to the drive shaft and the seal collar before assembly.
(3) Torque for the full nut ... 60 to 70 N·m (44 to 50 lb ft)
Note: Use the nearest key slot to lock the cotter pin in the full nut.
(5) Torque for the locknut ... 70 to 80 N·m (50 to 60 lb ft)
Note: Use required numbers of 0.25 (0.010) and 0.38 mm (0.015 inch) shims to obtain the axial clearance of the impeller.
(6) Axial clearance on each side of the impeller ... 0.10 to 0.15 mm (0.004 to 0.006 inch)
Caterpillar Information System:
C6.6 Engines for Caterpillar Built Machines Electronic Unit Injector - Install
320 Variable Gauge OEM Undercarriage Safety Messages
Proper Sizing of Ground to Neutral Cables{7405} Proper Sizing of Ground to Neutral Cables{7405}
120 Motor Graders Temperature Sensor (Hydraulic Oil)
C9 Agricultural Engine for Challenger Tractors Intake Manifold Air Temperature Is High
C9 Agricultural Engine for Challenger Tractors Exhaust Temperature Is High
C32 Marine Engine Control Panel
2007/07/09 Improved Mounting and Wiring for the Power Distribution Box {1000, 1408, 7426}
C32 Marine Propulsion Engines Indicator Lamp - Test
G3520B Industrial Engines Air/Fuel Ratio Problem
C7 On-highway Engine Exhaust Extension
C13 and C15 On-highway Engines Coolant Temperature Is Low
C15 On-Highway Engine Compression Brake
C15 Generator Set Engines 5 Volt Engine Pressure Sensor Supply Circuit - Test
C15 On-Highway Engine Turbocharger Outlet Temperature Sensor - Remove and Install
C15 On-Highway Engine Flame Detection Temperature Sensor - Remove and Install
Proper Marking of the Ground Connections{4459} Proper Marking of the Ground Connections{4459}
2007/05/21 New Procedure to Seal Planetary Tie Bolts to the Transmission Housing is Now Used {3160}
C15 Generator Set Engines Engine Pressure Sensor Open or Short Circuit - Test
2007/06/25 New O-Rings are Used {1307, 7555}
AccuGrade® GPS (CD700) Receiver Configuration
3408B and 3408C Industrial and Marine Engines Fuel Injection Pump
3408B and 3408C Industrial and Marine Engines Flywheel
C9 On-highway Engine Clean Gas Induction Cooler