Crankshaft
Show/hide table
| 图 1 | g01447246 |
(A) 齿轮尺寸
- 组装后齿轮的平均直径 ... 112.48 ± 0.10 mm (4.428 ± 0.004 in)
- 组装后齿轮的最大直径 ... 112.63 mm (4.434 in)
注: 曲轴组装到缸体中后，曲轴的轴向间隙应当在 0.07 到 0.32 mm (0.003 到 0.013 in) 之间。
Caterpillar Information System:
320D and 323D Excavators Machine System Specifications Pilot Valve (Joystick)
12M Motor Grader Work Tool Lift - Lubricate
C7 Engines for Caterpillar Built Machines Water Temperature Regulator
C7 Engines for Caterpillar Built Machines Water Temperature Regulator
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Oil Lines
C1.5 and C2.2 Engines for Caterpillar Built Machines Turbocharger
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Injection Lines
2006/09/01 277-4734 Bypass Harness Assembly Allows Cat Electronic Technician (Cat ET) to Communicate with ADEM IV:E2 Electronic Control Modules {0779, 0785, 1901, 1930}
12M Motor Grader Scarifier Teeth - Inspect/Replace - If Equipped
C280-12 and C280–16 Marine Engines Idler Gears (Rear) - Install
12M Motor Grader Scarifier Lift Link Socket - Lubricate - If Equipped
C280-12 and C280–16 Marine Engines Idler Gears (Rear) - Remove
C15 and C18 Petrolem Generator Set Engines ECM Software - Install
C1.5 and C2.2 Engines for Caterpillar Built Machines Fan Drive
390F Excavator Machine Systems Swing Drive - Disassemble
C7 Engines for Caterpillar Built Machines Crankshaft Seals
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Controller Board Battery - Replace
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys DC Bus Voltage - Calibrate
3606 and 3608 Engines Housing (Rear) - Remove
390F Excavator Machine Systems Swing Drive - Assemble
C7 Engines for Caterpillar Built Machines Piston Cooling Jet
C7 Engines for Caterpillar Built Machines Piston Cooling Jet
C15 On-Highway Engine ARD Combustion Air Pressure Sensor - Remove and Install - Differential Pressure
3606 and 3608 Engines Housing (Rear) - Install