Engine Oil Lines
Show/hide table
图 1 | g01093847 |
典型例子 |
(1) 发动机油管
(2) 垫圈
注: 拆下发动机油管时,必须用新垫圈更换这些垫圈。
(3) 空心螺栓的扭矩 ... 12 N·m (9 lb ft)
Caterpillar Information System:
C1.5 and C2.2 Engines for Caterpillar Built Machines Turbocharger
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Injection Lines
2006/09/01 277-4734 Bypass Harness Assembly Allows Cat Electronic Technician (Cat ET) to Communicate with ADEM IV:E2 Electronic Control Modules {0779, 0785, 1901, 1930}
12M Motor Grader Scarifier Teeth - Inspect/Replace - If Equipped
C280-12 and C280–16 Marine Engines Idler Gears (Rear) - Install
12M Motor Grader Scarifier Lift Link Socket - Lubricate - If Equipped
C280-12 and C280–16 Marine Engines Idler Gears (Rear) - Remove
307B, 311–330 B-D Series, 345–5090 B and C Series and M312-M322 A-D Series Excavators Bucket - Remove and Install
Using the Map Adjustment Feature{1901, 1902, 7620} Using the Map Adjustment Feature{1901, 1902, 7620}
TA22 Transmission Relief Valve - Remove and Install - Lube Relief Valve
C13 and C15 On-highway Engines Indicator Lamp - Test
C13 and C15 On-highway Engines Auxiliary Brake - Test
C7 Engines for Caterpillar Built Machines Water Temperature Regulator
C7 Engines for Caterpillar Built Machines Water Temperature Regulator
12M Motor Grader Work Tool Lift - Lubricate
320D and 323D Excavators Machine System Specifications Pilot Valve (Joystick)
C7 Engines for Caterpillar Built Machines Crankshaft
C15 and C18 Petrolem Generator Set Engines ECM Software - Install
C1.5 and C2.2 Engines for Caterpillar Built Machines Fan Drive
390F Excavator Machine Systems Swing Drive - Disassemble
C7 Engines for Caterpillar Built Machines Crankshaft Seals
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Controller Board Battery - Replace
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys DC Bus Voltage - Calibrate
3606 and 3608 Engines Housing (Rear) - Remove