Cooling System Coolant (ELC) - Change
Show/hide table
增压系统: 热的冷却液能造成严重的烫伤。 为了打开盖子,要停机,等候散热器冷下来。 然后慢慢松开盖子,释放压力。 |
- 把发动机室上方的小检修门 (1) 打开。 轻轻掀开冷却系统的压力盖,以释放系统压力。
Show/hide table
注意 在检查、保养、测试、调整及维修产品时,请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前,请准备好盛接液体用的适当容器。
Show/hide table图 2 g01273210 - 冷却液排放阀位于机器后面的下部。 打开排放阀。 使冷却液排放到适当的容器中。
- 用净水冲刷冷却系统直到排出的水清澈为止。 关闭排放阀。
- 更换水温调节器。
参考: 关于正确的更换步骤,请参阅操纵和保养手册, "冷却系统水温调节器 - 更换"。
Show/hide table注意 将 卡特彼勒 长效性冷却液加上或混和其它不符合 卡特彼勒 EC-1 技术规格的冷却液会降低冷却液的功效和缩短冷却液的工作寿命。
对于预混合或浓缩的冷却液,只能使用卡特彼勒 产品或符合卡特彼勒EC-1 规格的市售产品。 所有的延长剂只能是卡特彼勒 ELC。
不遵循这些建议会缩短冷却系统零部件的寿命。
- 添加
268 L (71 US gal) 长效冷却液(ELC)。 - 起动发动机。 在没有压力盖的情形下开动发动机,直至节温器打开,和冷却液的液面稳定为止。
- 观察目测表 (2) 以便保持冷却液液位。
- 安装冷却系统压力盖。 关闭检修门。
Show/hide table
图 1 | g01273221 |
如果您的机器配备有维修中心,则可通过快速加注口排放或加注冷却液。
Show/hide table
图 3 | g01338918 |
- 拆卸防尘盖 (3)。
- 将软管连接到外接头上。 该加注口应使用 127-9087 管嘴。
- 根据需要排放或加注冷却液。
参考: 有关更多信息,请参阅操作和保养手册, "维修中心"。
Caterpillar Information System:
C7 Engine for the AP-755 Asphalt Paver and the PM-102 Cold Planer CID 2766 FMI 02 Intermediate Engine Speed Switch erratic, intermittent, or incorrect
3508 EUI Engine for Off-Highway Truck/Tractors Fan Drive
525C Wheel Skidder, 535C Wheel Skidder and 545C Wheel Skidder Power Train Transmission Case and Parts Group
C4.4 Industrial Engine Flywheel Housing - Inspect
D6G Series 2 Track-Type Tractor Hydraulic System Bulldozer Lift Control Valve
C4.4 Industrial Engine Flywheel - Inspect
D9T Track-Type Tractor Machine Systems Fast Fill Fuel Adapter
D9T Track-Type Tractor Machine Systems Fast Fill Fuel Adapter
C4.4 Industrial Engine Gear Group - Inspect
657G Wheel Tractor-Scraper Hydraulic System Cylinder Cycle Time - Check
525C Wheel Skidder, 535C Wheel Skidder and 545C Wheel Skidder Power Train Transmission Control Valve
2006/05/22 Replacing Both Hydrostatic Pumps Restores Straight Tracking {5070}
657G Wheel Tractor-Scraper Machine Systems Push-Pull Hook - Remove and Install
3508 EUI Engine for Off-Highway Truck/Tractors Auxiliary Water Pump
631G and 637G Wheel Tractor-Scrapers Auger Hydraulic System Gear Pump (Auger)
D8T Track-Type Tractor Machine Systems Fast Fill Fuel Adapter
D8T Track-Type Tractor Machine Systems Fast Fill Fuel Adapter
525C, 535C and 545C Wheel Skidders Power Train Drive Shaft (Center) - Remove and Install
657G Wheel Scraper Power Train Drive Shaft - Remove and Install
854K Wheel Dozer Safety Messages
3508 EUI Engine for Off-Highway Truck/Tractors Cylinder Block
C7 Engine for the AP-755 Asphalt Paver and the PM-102 Cold Planer Engine Temperature Sensor Open or Short Circuit - Test
C4.4 Industrial Engine Air Inlet and Exhaust System - Inspect
2006/05/29 Updated Plate Assembly Eliminates Interference For the Cable On the Cab Heater {7304}