Flywheel - Install
Show/hide table
| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | - | Guide Stud 5/8 - 18 UNF by 11 inch |
2 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Raise the temperature of ring gear (3). Install ring gear (3) on flywheel (2).
- Install Tooling (A) in the crankshaft.
- Attach a suitable lifting device to flywheel (2). The weight of flywheel (2) is approximately
53 kg (117 lb) . Position flywheel (2) on the crankshaft.Show/hide table
Illustration 2 g01203091 - Apply clean engine oil to the threads of bolts (1).
- Install bolts (1) in flywheel (2). Remove Tooling (A). Install remaining bolts (1).
- Tighten bolts (1) to a torque of
360 ± 25 N·m (266 ± 19 lb ft) . - Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect".
Show/hide table
| |
| Illustration 1 | g01203092 |
Note: Ring gear (3) must be installed with the chamfered side of the teeth upward. The chamfered side of the gear teeth will be facing toward the starting motor when the flywheel is installed.
Caterpillar Information System:
Cat Commercial Diesel Engine Fluids Recommendations S·O·S Services Oil Analysis
Caterpillar On-Highway Diesel Engine Fluids Recommendations S·O·S Services Coolant Analysis
Mechanical Application and Installation Guide for the TH48-E80 Petroleum Transmission{3030, 3101} Mechanical Application and Installation Guide for the TH48-E80 Petroleum Transmission{3030, 3101}
3412 Generator Set Engines Turbocharger Oil Lines - Single Turbocharger Configuration
3412 Generator Set Engines Turbocharger Oil Lines - Series Turbocharger Configuration
3412 Generator Set Engines Turbocharger Oil Lines - Twin Turbocharger Configuration
C175-16 and C175-20 Engines for Caterpillar Built Machines Camshaft Bearings - Remove
C175-16 and C175-20 Engines for Caterpillar Built Machines Rocker Shaft and Push Rods - Install
C32 Petroleum Engines Flywheel - Remove
3412 Generator Set Engines Valve Mechanism Cover
C175-16 and C175-20 Engines for Caterpillar Built Machines Rocker Shaft and Push Rods - Remove
C175 Generator Set Engines Crankcase Breather - Remove and Install
C9 Generator Set Engines Injector Solenoid Circuit - Test
C175-16 and C175-20 Engines for Caterpillar Built Machines Camshaft Bearings - Install
C32 Petroleum Engines Flywheel Housing - Remove and Install
3412 Generator Set Engines Turbocharger
G3500 A3 Engines Diagnostic Code List
3412 Generator Set Engines Turbocharger
3412 Generator Set Engines Turbocharger
3412 Generator Set Engines Turbocharger
G3500 A3 Engines Event Code List - Oxygen Feedback
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Control Valve (Counterweight Circuit) - Disassemble
345C Excavator and 345C MHPU Mobile Hydraulic Power Unit Machine Systems Control Valve (Counterweight Circuit) - Assemble
3412 Generator Set Engines Air Inlet and Exhaust Lines - Series Turbocharger Configuration