Customer Specified Parameters Table
Show/hide table
Customer Specified Parameters     | ||
---|---|---|
ECM Parameter     | Possible Values     | Default Value     |
Engine Rating Parameter     | ||
"Rating Number"     | 1 to 4     | 1     |
Low/High Idle Parameters     | ||
"Low Idle Speed"     | 700 to 1200 rpm     | 750 rpm     |
"High Idle Speed"     | 1900 to 2900 rpm     | 2650 rpm     |
ECM Identification Parameter     | ||
"Equipment ID"     | 17 Digits Available characters are dependent on the service tool that is used     |
Not Programmed     |
PTO and Throttle Lock Parameters     | ||
"Throttle Lock Feature Installation Status"     | Installed Not Installed     |
Not Installed     |
"PTO Engine Speed Setting"     | 0 to 3000 rpm     | 0 rpm     |
"Throttle Lock Increment Speed Ramp Rate"     | 0 to 600 rpm/sec     | 400 rpm/sec     |
"Throttle Lock Engine Set Speed Increment"     | 0 to 200 rpm     | 10 rpm     |
Miscellaneous     | ||
"Monitoring Mode Shutdowns"     | Disabled Enabled     |
Disabled     |
"Monitoring Mode Derates"     | Disabled Enabled     |
Enabled     |
"Limp Home Desired Engine Speed"     | 700 to 1800 rpm     | 1200 rpm     |
J1939 Continuous Fault Handling     | ||
"Remote Torque Speed Control Enable Status"     | Disabled Enabled     |
Disabled     |
Configurable Inputs     | ||
"Coolant Level Sensor"     | Not Installed Installed     |
Not Installed     |
"Air Filter Restriction Switch Installation Status"     | Not Installed Installed     |
Not Installed     |
"Fuel/Water Separator Switch Installation Status"     | Not Installed Installed     |
Not Installed     |
"User Defined Switch Installation Status"     | Not Installed Installed     |
Not Installed     |
Caterpillar Information System:
C9 Generator Set Electrical Connections - Check
C7 On-highway Engine Fan Drive Mounting Group
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Fan Drive - Assemble
C-12 Generator Set Engine Engine Speed/Timing Sensor Circuit - Test
C3.3 and C4.4 Generator Sets Engine Air Cleaner Element (Single Element) - Replace
C7 On-highway Engine Belt Tensioner
Worksheet for the Diagnosis of Fuel Injectors{1254, 1290} Worksheet for the Diagnosis of Fuel Injectors{1254, 1290}
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Fan Drive - Disassemble
C9 On-highway Engine Exhaust Manifold
C7 On-highway Engine Flywheel
C-12 Generator Set Engine Cat Data Link Circuit - Test
C175 Generator Sets Parallel Operation
C-12 Generator Set Engine Injector Solenoid Circuit - Test
3500 Generator Sets Model View Illustrations
C-12 Generator Set Engine Engine Speed/Timing Sensor - Calibrate
C1.5 and C2.2 Generator Set Engines Exhaust Manifold - Remove and Install
C27 and C32 Industrial and Petroleum Engines Engine Design
345C MHPU Mobile Hydraulic Power Unit Engine Supplement Radiator - Remove
C1.5 and C2.2 Generator Set Engines Inlet and Exhaust Valves - Remove and Install
C-12 Generator Set Engine Coolant in Engine Oil
C-12 Generator Set Engine Coolant Temperature Is Too High
C1.5 and C2.2 Generator Set Engines Engine Oil Line - Remove and Install
C-12 Generator Set Engine ECM Will Not Communicate with Other Systems or Display Modules
3126B Generator Set Engine Engine Cranks but Will Not Start