Engine Oil Filter Base
Show/hide table
Illustration 1 | g01519000 |
Use the manual tightening sequence that is shown in Illustration 1.
- In the numerical sequence, hand tighten all the bolts until all the bolts contact the base.
- In the numerical sequence, tighten the bolts to
21 ± 7 N·m (15 ± 5 lb ft) . - In the numerical sequence, again tighten the bolts to
28 ± 7 N·m (21 ± 5 lb ft) .
Show/hide table
Illustration 2 | g01519089 |
(1) Torque for two flat head screws ...
Show/hide table
Illustration 3 | g01519117 |
(2) 242-3864 Spring
- Quantity ... 2
- Length under test force ...
43.18 mm (1.700 inch) - Test force ...
43.7 N (9.8 lb) - Free length after test ...
58.50 ± 0.50 mm (2.303 ± 0.020 inch) - Outside diameter ...
11 mm (0.4 inch) - Length under test force ...
Show/hide table
Illustration 4 | g01519138 |
(C) Length for applying 154-9731 Thread Lock Compound to the threads of the hollow stud ...
(3) Torque for two hollow studs ...
Caterpillar Information System:
C9 Generator Set Safety Messages
C15 On-Highway Engine Camshaft
349F and 352F Excavators Machine System Specifications Travel Counterbalance Valve
C2.2 Generator Sets Control Panel
C7 and C9 On-highway Engines Fuel System - Prime
TH48-E80 Petroleum Transmission Pressure Control Valve (Transmission)
325D and 329D Excavators Hydraulic System Hydraulic Tank and Filter
C9 Engines for Caterpillar Built Machines Coolant Temperature Sensor
C175 Generator Sets High Pressure Fuel Lines
Hydraulic Cylinder Honing {7562} Hydraulic Cylinder Honing {7562}
C7 On-highway Engine Water Lines
Installation of the 264-8897 Auxiliary Sea Water Pump Gp {1371} Installation of the 264-8897 Auxiliary Sea Water Pump Gp {1371}
C9 Generator Set Plate Locations and Film Locations
C9 Generator Set Model View Illustrations
C15 On-Highway Engine Crankshaft
C9 Engine for Caterpillar Built Machines Turbocharger - Remove
C13 On-highway Engine Front Housing and Covers
C9 Engine for Caterpillar Built Machines Turbocharger - Install
C9 Engine for Caterpillar Built Machines Cylinder Head - Remove
C15 On-Highway Engine Electronic Unit Injector
2006/02/06 A New Exhaust Manifold Gasket is Used {1059}
C15 and C18 Engines for Caterpillar Built Machines Electronic Unit Injector Rocker Arm
C2.2 Generator Sets Starting the Engine
C15 and C18 Engines for Caterpillar Built Machines Valve Rocker Arm