Fuel System - Prime
Show/hide table
| |
| Illustration 1 | g00791684 |
The priming pump is located on the right side of the machine in the engine compartment.
- Your machine is equipped with an electric fuel pump. The toggle switch (1) for the electric fuel pump is located near the fuel filter on the right side of the engine.
- A plug (2) is located on the secondary filter. The plug is used in order to purge air from the fuel lines.
- Use the toggle switch in order to operate the electric fuel pump. Open the plug. Operate the fuel priming pump until no air bubbles are present from the plug.
- Tighten the plug when air bubbles are no longer present. Turn off the fuel priming pump.
If the engine does not start or the engine misfires, further priming is necessary.
Caterpillar Information System:
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Power Train Systems MID 079 - CID 1708 - FMI 03
953C Track-Type Loader Power Train Synchronization Manifold
Adjustment and Modification Procedures to Alleviate Track Jumping/Indexing Adjustment and Modification Procedures to Alleviate Track Jumping/Indexing
953C Track-Type Loader Power Train Electronic Control Module Manifold
IT12F, IT14F, IT18F, IT24F and IT28F Integrated Toolcarriers and 910F, 918F, 924F and 928F Wheel Loaders Power Train Electronic Control System Related Components
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Power Train Systems MID 079 - CID 1707 - FMI 06
953C Track-Type Loader Power Train Hydraulic Oil Filter
3054 Engine Cooling System - Check
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Power Train Systems MID 079 - CID 1707 - FMI 05
3056 Engine for Caterpillar Built Machines Cooling System - Test
953C Track-Type Loader Power Train Hydrostatic Drive Pump
950G Wheel Loader, 962G Wheel Loader and IT62G Integrated Toolcarrier Hydraulic System Solenoid Valve (Quick Coupler)
621G and 627G Wheel Tractor-Scrapers Machine Systems Hydraulic Tank - Install
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Power Train Systems MID 079 - CID 1708 - FMI 05
2001/08/06 Repair for Exhaust Manifold Studs on 3306 Engines {1059}
IT12F, IT14F, IT18F, IT24F and IT28F Integrated Toolcarriers and 910F, 918F, 924F and 928F Wheel Loaders Power Train Electronic Control System Using Caterpillar Electronic Technician to Determine Diagnostic Codes
3054 Engine Increased Engine Oil Temperature - Inspect
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Power Train Systems MID 079 - CID 1708 - FMI 06
D3G, D4G and D5G Track-Type Tractors Electrohydraulic Power Train Systems Speed Indicator
816F Landfill Compactor, 815F Soil Compactor and 814F Wheel Dozer Ether Starting Aid Cylinder - Replace
3054 Engine Low Idle RPM - Adjust
3054 Engine High Idle RPM - Adjust
816F Landfill Compactor, 815F Soil Compactor and 814F Wheel Dozer Fuel Tank Cap and Strainer - Clean
3054 Engine Turbocharger - Inspect