Diagnostic Code Cross Reference
Problems with the electronic control system are reported via the following different types of codes: flash codes, SPN/FMI codes, diagnostic codes, and event codes.
For information on flash codes, refer to Troubleshooting, "Flash Codes".
For information on SPN/FMI codes, refer to Troubleshooting, "Diagnostic Codes".
For information on diagnostic codes, refer to Troubleshooting, "Diagnostic Codes".
For information on event codes, refer to Troubleshooting, "Event Codes".
Cross-Reference for Flash Code to CID-FMI (Diagnostics) or EID (Events)
Portions of this material are reprinted with permission from SAE J1939DA_201607© 2016 SAE International. SAE International is not responsible for any use or translation of this material, in whole or in part. Please contact SAE International to obtain a complete copy of SAE J1939DA_201607, the official definitive source of this standard.
Show/hide table
| Cross-Reference for Flash Code to CID-FMI (Diagnostics) or EID (Events) | ||
|---|---|---|
| Flash Code | CID-FMI or EID | Description of Code |
| 13 | 174-03 | Fuel Temperature open/short to +batt |
| 174-04 | Fuel Temperature short to ground | |
| 15 | 96-03 | Fuel Level Sensor open/short to +batt |
| 96-04 | Fuel Level Sensor short to ground | |
| 21 | 262-03 | 5 Volt Sensor DC Power Supply short to +batt |
| 262-04 | 5 Volt Sensor DC Power Supply short to ground | |
| 41-03 | 8 Volt DC Supply short to +batt | |
| 41-04 | 8 Volt DC Supply short to ground | |
| 24 | 100-03 | Engine Oil Pressure open/short to +batt |
| 100-04 | Engine Oil Pressure short to ground | |
| 25 | 102-03 | Boost Pressure Sensor open/short to +batt |
| 102-04 | Boost Pressure Sensor short to ground | |
| 27 | 110-03 | Engine Coolant Temperature open/short to +batt |
| 110-04 | Engine Coolant Temperature short to ground | |
| 28 | 91-13 | Throttle Position Calibration required |
| 1249-13 | Secondary Throttle Position calibration required | |
| 32 | 91-08 | Throttle Position signal abnormal |
| 1249-08 | Secondary Throttle Position signal abnormal | |
| 34 | 320-02 | Speed/Timing Sensor Loss of Signal |
| 320-11 | Speed/Timing Sensor mechanical failure | |
| 342-02 | Loss of Secondary Engine Speed signal | |
| 342-11 | Secondary Engine Speed Sensor mechanical failure | |
| 35 | E190 | Engine Overspeed Warning |
| 36 | E268 | Unidentified Shutdown |
| 37 | 94-03 | Fuel Pressure open/short to +batt |
| 94-04 | Fuel Pressure short to ground | |
| 38 | 105-03 | Inlet Manifold Temp Sensor open/short to +batt |
| 105-04 | Inlet Manifold Temp Sensor short to ground | |
| 42 | 261-13 | Engine Timing Calibration required |
| 46 | E039 | Low Engine Oil Pressure Derate |
| E100 | Low Engine Oil Pressure Warning | |
| 51 | 168-02 | System Voltage intermittent |
| 53 | 254-12 | Electronic Control Module Error |
| 56 | 268-02 | Check Programmable Parameters |
| 58 | E057 | Low Engine Coolant Level Derate |
| E059 | Low Engine Coolant Level Warning | |
| 59 | 253-02 | Personality Module mismatch |
| 61 | E015 | High Engine Coolant Temperature Derate |
| E017 | High Engine Coolant Temperature Warning | |
| 63 | E096 | High Fuel Pressure |
| 64 | E025 | High Inlet Air Temperature Derate |
| E027 | High Inlet Air Temperature Warning | |
| 65 | E056 | High Fuel Temperature Warning |
| 66 | E030 | High Transmission Oil Temperature Warning |
| 67 | 177-03 | Transmission Oil Temperature open/short to +batt |
| 177-04 | Transmission Oil Temperature short to ground | |
| 68 | 127-03 | Transmission Oil Pressure open/short to +batt |
| 127-04 | Transmission Oil Pressure short to ground | |
| 69 | E113 | High Transmission Oil Pressure |
| 71 | 1-11 | Injector Cylinder #1 fault |
| 72 | 2-11 | Injector Cylinder #2 fault |
| 73 | 3-11 | Injector Cylinder #3 fault |
| 74 | 4-11 | Injector Cylinder #4 fault |
| 75 | 5-11 | Injector Cylinder #5 fault |
| 76 | 6-11 | Injector Cylinder #6 fault |
Cross-Reference for SPN-FMI Code to CID-FMI (Diagnostics) or EID (Events)
Show/hide table
| Cross-Reference for SPN(1)-FMI Code to CID-FMI (Diagnostics) or EID (Events) | ||
|---|---|---|
| SPN/FMI Code | CID-FMI or EID | Description of Code |
| 91-08 | 91-08 | Throttle Position signal abnormal |
| 91-13 | 91-13 | Throttle Position Calibration required |
| 94-00 | E096 | High Fuel Pressure |
| 94-03 | 94-03 | Fuel Pressure open/short to +batt |
| 94-04 | 94-04 | Fuel Pressure short to ground |
| 96-03 | 96-03 | Fuel Level Sensor open/short to +batt |
| 96-04 | 96-04 | Fuel Level Sensor short to ground |
| 96-17 | E119 | Low Fuel Level |
| 100-03 | 100-03 | Engine Oil Pressure open/short to +batt |
| 100-04 | 100-04 | Engine Oil Pressure short to ground |
| 100-17 | E100 | Low Engine Oil Pressure Warning |
| 100-18 | E039 | Low Engine Oil Pressure Derate |
| 102-03 | 102-03 | Boost Pressure Sensor open/short to +batt |
| 102-04 | 102-04 | Boost Pressure Sensor short to ground |
| 110-03 | 110-03 | Engine Coolant Temperature open/short to +batt |
| 110-04 | 110-04 | Engine Coolant Temperature short to ground |
| 110-15 | E017 | High Engine Coolant Temperature Warning |
| 110-16 | E015 | High Engine Coolant Temperature Derate |
| 111-17 | E059 | Low Engine Coolant Level Warning |
| 111-18 | E057 | Low Engine Coolant Level Derate |
| 127-03 | 127-03 | Transmission Oil Pressure open/short to +batt |
| 127-04 | 127-04 | Transmission Oil Pressure short to ground |
| 127-15 | E113 | High Transmission Oil Pressure |
| 168-02 | 168-02 | System Voltage intermittent |
| 172-03 | 105-03 | Inlet Manifold Temp Sensor open/short to +batt |
| 172-04 | 105-04 | Inlet Manifold Temp Sensor short to ground |
| 172-15 | E027 | High Inlet Air Temperature Warning |
| 172-16 | E025 | High Inlet Air Temperature Derate |
| 174-03 | 174-03 | Fuel Temperature open/short to +batt |
| 174-04 | 174-04 | Fuel Temperature short to ground |
| 174-15 | E056 | High Fuel Temperature Warning |
| 177-03 | 177-03 | Transmission Oil Temperature open/short to +batt |
| 177-04 | 177-04 | Transmission Oil Temperature short to ground |
| 177-15 | E030 | High Transmission Oil Temperature Warning |
| 190-00 | E190 | Engine Overspeed Warning |
| 820-02 | 320-02 | Speed/Timing Sensor Loss of Signal |
| 820-11 | 320-11 | Speed/Timing Sensor mechanical failure |
| 228-13 | 261-13 | Engine Timing calibration required |
| 253-02 | 253-02 | Personality Module mismatch |
| 515-08 | 1249-08 | Secondary Throttle Position signal abnormal |
| 515-13 | 1249-13 | Secondary Throttle Position calibration required |
| 620-03 | 262-03 | 5 Volt Sensor DC Power Supply short to +batt |
| 620-04 | 262-04 | 5 Volt Sensor DC Power Supply short to ground |
| 651-11 | 1-11 | Injector Cylinder #1 fault |
| 652-11 | 2-11 | Injector Cylinder #2 fault |
| 653-11 | 3-11 | Injector Cylinder #3 fault |
| 654-11 | 4-11 | Injector Cylinder #4 fault |
| 655-11 | 5-11 | Injector Cylinder #5 fault |
| 656-11 | 6-11 | Injector Cylinder #6 fault |
| 678-03 | 41-03 | 8 Volt DC Supply short to +batt |
| 678-04 | 41-04 | 8 Volt DC Supply short to ground |
| 723-02 | 342-02 | Loss of Secondary Engine Speed signal |
| 723-11 | 342-11 | Secondary Engine Speed Sensor mechanical failure |
| 1111-02 | 268-02 | Check Programmable Parameters |
| 1383-11 | E268 | Unidentified Shutdown |
Show/hide table
| (1) | Suspect Parameter Number |
Caterpillar Information System:
C11 and C13 Petroleum Engines Cylinder Head - Install
C11 and C13 Petroleum Engines Cylinder Head - Remove
C7 and C9 Marine Engines Transmission Oil Temperature Sensor Open or Short Circuit - Test
C7 and C9 Marine Engines Switch Circuits - Test
C7 and C9 Marine Engines Injector Solenoid Circuit - Test
C7 and C9 Marine Engines Indicator Lamp Circuit - Test
C7 and C9 Marine Engines Engine Temperature Sensor Open or Short Circuit - Test
C7 and C9 Marine Engines Engine Speed/Timing Sensor Circuit - Test
C7 and C9 Marine Engines Engine Pressure Sensor Open or Short Circuit - Test
C7 and C9 Marine Engines Electrical Power Supply Circuit - Test
C7 and C9 Marine Engines Digital Sensor Supply Circuit - Test
C7 and C9 Marine Engines CAN Data Link Circuit - Test
2005/03/07 Factory Password System for Caterpillar ECM Engines {1000, 1900, 7620}
C7 and C9 Marine Engines Injection Actuation Pressure Sensor - Test
C27 and C32 Generator Set Engines Cylinder Liner - Remove
C27 and C32 Generator Set Engines Cylinder Liner - Install
C7 and C9 Marine Engines Event Codes
C27 and C32 Generator Set Engines Piston Cooling Jets - Remove and Install
C27 and C32 Generator Set Engines Pistons and Connecting Rods - Remove
C27 and C32 Engines for Caterpillar Built Machines Pistons and Connecting Rods - Assemble
C27 and C32 Generator Set Engines Pistons and Connecting Rods - Install
2005/03/14 The Cylinder Liners Have a New Appearance {1216}
2005/03/14 The Cylinder Liners Have a New Appearance {1216}
C27 and C32 Generator Set Engines Connecting Rod Bearings - Remove